Multiple-objective Optimization of Serpentine Locomotion with Snake Robot by Using the NSGA

Journal of Simulation and Analysis of Novel Technologies in Mechanical Engineering

مقاله 6، دوره 4، شماره 2، آذر 2011، صفحه 57-74   

نوع مقاله: Persian

نویسندگان

Hadi Kalani¹؛ Alireza Akbarzadeh^{* 2}

¹Assistant Professor, Center of Excellence on Soft Computing and Intelligent Information Processing, Mechanical Engineering Department, Ferdowsi University of Mashhad, Mashhad, Iran.

².D. Student , Center of Excellence on Soft Computing and Intelligent Information Processing, Mechanical Engineering Department, Ferdowsi University of Mashhad, Mashhad, Iran

چکیده

This paper starts with developing kinematic and dynamic model of a snake shape robot in serpentine locomotion and finishes with actual experimentation. At the beginning the symmetrical and unsymmetrical serpenoid curves are introduced. Kinematics and dynamics of a snake robot on flat and inclined surfaces are obtained for a general n-link robot. SimMechanics toolbox of MATLAB software is employed to simulate the snake robot. Effects of serpenoid curve parameters on joint torques and progression of the snake robot are also investigated. Results indicate that by increasing the inclination angle of the surface, link length and numbers of links, joint torques are increased. NSGA multi optimization method is next utilized to obtain the unsymmetrical curve parameters resulting in minimum joint torques and maximum snake progression. Optimal solutions are presented in the form of Pareto front optimal. The optimization shows that the required range of parameters of snake robot's body curve for higher progression and less torque, is limited. Additionally, it is shown that by employing the unsymmetrical serpenoid curves the efficiency of snake robot can be increased. Finally, FUM-Snake I robot is employed to validate the theoretical results on a flat surface. The experimental results show that the proposed kinematics and dynamics model are reasonable.

کلیدواژه‌ها

Snake-like robot؛ Serpentine locomotion؛ Kinematics؛ Dynamics؛ Serpenoid curve؛ NSGA Optimization

مراجع

[1]     Hirose S., Biologically Inspired Robots (Snake-like Locomotor and Manipulator), Oxford University Press ,1993.

[2]     Saito M., Fukaya M., Iwasaki T.,Serpentine locomotion with robotic snakes, IEEE Control Systems Magazine, Vol. 22,   2002, pp. 64–81.

[3]     Andreas Transeth A., Modelling and Control of Snake Robots, Ph.D. Dissertation, Trondheim, 2007.

[4]     Andreas Transeth A., Ytterstad Pettersen K., Liljebäck P., A survey on snake robot modeling and locomotion, Robotica, Vol.  27,  ,2009, pp. 999–1015 .

[5]     Vossoughi Gh., Pendar Ho., Heidari Z., Mohammadi S., Assisted passive snake-like robots: conception and dynamic modeling using Gibbs–Appell method, Robotica, Vol. 26, 2008, pp. 267–276.

[6]     Spranklin B. W., Design, Analysis and fabrication of a snake- inspired robot with a rectilinear gait, Master of Science Thesis, University of Maryland,2006.

[7]     Liljebäck P., Stavdahl O., Pettersen K. Y., Modular pneumatic snake robot: 3D modelling, implementation and control,  Proc. 16^th IFAC World Congress, Prague, Czech Republic ,2005.

[8]     Ye Ch., Ma Sh., Li B., Development of a 3D Snake-like Robot Perambulator-II: Design and Basic Experiments, Proc. 2007 IEEE Int. Conf. on Intelligent Mechatronics and Automation (ICMA2007), 2007.8,  pp. 117-122, Harbin, Heilongjiang, China.

[9]     Crespi A. , Ijspeert A. J., Online Optimization of Swimming and Crawling in an Amphibious Snake Robot, IEEE Transactions of Robotics, Vol. 24, No. 1, 2008.

[10]    Hasanzadeh Sh., Akbarzadeh A., Ground adaptive and optimized locomotion of snake robot moving with a novel gait,  Auton Robot. Vol. 28, 2010, pp. 457–470.

[11]    Hasanzadeh Sh., Akbarzadeh Tootoonchi A., Adaptive Optimal Locomotion of Snake Robot Based on CPG-Network Using Fuzzy Logic Tuner, IEEE - CIS RAM,2008 , 2008-09-22.

[12]    Kalani H., Akbarzadeh A., Design and Modeling of a Snake Robot Based on Worm-Like Locomotion, Accepted, Advance Robotics.

[13]    Kalani H., Akbarzadeh A., Safehian J., Traveling Wave Locomotion of Snake Robot along Symmetrical and Unsymmetrical body shapes, ISR-Robotik, Munich, Germany,2010.

[14]    Safehian J., kalani H., Akbarzadeh A., A Novel Kinematics Modeling Method for Snake Robot in Traveling wave Locomotion, ASME, Turkish ,2010.

[15]    Horn J., Nafpliotis N., Goldberg D., A niched pareto genetic algorithm for multiobjective optimization, NJ:IEEE World Congress on Computational Intelligence, IEEE, 1994, p. 82–7.

[16]    Fonseca C.M., Fleming P.J., Genetic algorithms for multiobjective optimization: formulation, discussion and generalization , Proceedings of the fifth international conference on genetic algorithms, San Mateo California, 1993, pp. 416–23.

[17]    Deb K., Agarwal S., Pratap A., Meyarivan T., A fast elitist nondominated sorting genetic algorithm for multi-objective optimization: NSGA-II., KanGAL report number 2001. Kanpur, India: Indian Institute of Technology; 2000.

[18]    Deb K., Agarwal S., Pratap A., Meyarivan T., A fast elitist nondominated sorting genetic algorithm for multi-objective optimization: NSGA-II., Proceedings of the parallel problem solving from nature VI conference, Paris, France. 2000, pp. 849–58.

[19]    Schaffer J., Multiple objective optimization with vector evaluated genetic algorithms. Genetic algorithms and their applications, proceedings of the first international conference on genetic algorithms. Hillsdale, NJ. 1985. pp. 93–100.

[20]    Srinivas,  Deb A. , Multiobjective optimization using nondominated sorting in genetic algorithms,. Journal Evol. Comput., Vol.  2(3):, 1994 , pp. 221–48 1994.

[21]    Eckart Zitzler, Evolutionary Algorithms for Multiobjective Optimization: Methods and Applications, Ph.D. thesis, Swiss Federal Institute of Technology Zurich, 1999.

[22]    Kalani H., Akbarzadeh A., Bahrami H., Application of Statistical Techniques in Modeling and Optimization of a Snake Robot, Robotica, published online: November 2012 , pp.1–19 .