Analysis of PVC Frames Cutting by Guillotine and Presenting Solution on Preventing Imperfection

Journal of Simulation and Analysis of Novel Technologies in Mechanical Engineering

مقاله 2، دوره 2، شماره 1، آذر 2009، صفحه 11-17   

نوع مقاله: Persian

نویسندگان

Saeed Shiri¹؛ Mehran Moradi^{* 2}

¹M.Sc. Student, Islamic Azad University, Najafabad Branch

²Assistant Professor, Mechanical Engineering Department, Isfahan University of Technology

چکیده

PVC frame cutting process by guillotine is a common method that attracted attention of car parts and PVC decorating furniture producers. In this paper, the effects of main parameters such as cutting speed, lubricants and cutting frame holder pressure force on PVC frame section surface smoothness is investigated by experimental methods on a specified PVC frame sample and then by FEM simulation using ABAQUS 6.8 software. The results obtained by experimental methods and software simulation show intense effect of these parameters on the PVC frame section surface smoothness and cutting force. Finally, based on the experimental works, some solutions are suggested to improve the cutting quality.

کلیدواژه‌ها

Cutting process؛ Surface smoothness؛ PVC frame؛ FEM

مراجع

[1] Semsarzadeh A., Mehrabzadeh M., Mechanical and Thermal Properties of the Plasticized PVC-ESBO, Iranian polymer journal, no.14, 2006, pp.769-773.

 

[2] Gedde U., Polymer Physics, Chapman and hall, 1995.

 

[3] Jastrzebski Z. D., The Nature and Properties of Engineering Materials, 3rd ed., John Wiley and Sons, 1987.

[4] Lemaitre J., Desmorat R., Engineering Damage Mechanics, Springer-Verlag, Berlin Heidelberg, Printed in The Netherlands, 2005.

[5] اعلائی ج.، خوش نیت ع. ، رحمت پور ع. ، مطالعه خواص فیزیکی، مکانیکی و اشتغال پذیری آلیاژ ABS/PVC ، مجله پژوهش نفت، سال هجدهم ، شماره 57، 1387، صص 61-52.

 [6] باقری ر.، مبانی خواص مکانیکی پلاستیک­ها  ساختار مواد، انتشارات جهاد دانشگاهی واحد صنعتی اصفهان، 1381، صص 82-111.

[7] گنجی، کاربرد مواد PVC در صنعت، انتشارات نوپردازان، 1386، صص22-43.