Thermal and catalytic degradation study of polyethylene and investigation the catalytic effect of X-Zeolite and Silica-Alumina on degradation kinetic

Journal of the Iranian Chemical Research

مقاله 6، دوره 2، شماره 3، آذر 2009، صفحه 195-210   

نویسندگان

Mohammad Taghi Taghizadeh^* ؛ Parinaz Seifi-Aghjekohal؛ Ali Bahadori,؛ Banafsheh Zeraatkar

Department of Physical Chemistry, Faculty of Chemistry, University of Tabriz, Tabriz, Iran

چکیده

The thermal degradation of polyethylene (PE) was carried out in the absence and presence of
catalystes X-Zeolite and Silica-Alumina at different temperatures. The optimum PE/Catalysis
ratio was 0.25:0.05 g/g, which produced highest degradation value. PE and PE/Catalysis were
characterized by thermogravimetric analysis. The thermal degradation properties of polymer
have been studied by Infrared spectroscopy–FT-IR. Experimental data indicated that the
presence of catalysis greatly increased the rate of degradation of PE. The activation energy of
degradation for pure polyethylene and polyethylene in presence catalysises was calculated by
Arrhenius equation and Ozawa method. Activation energy follows the order PE < PE/Silica-
Alumina < PE/X-Zeolite.

کلیدواژه‌ها

Thermal degradation؛ Polyethylene؛ X-Zeolite؛ Silica-Alumina؛ Activation energies

مراجع

[1] R. Chandra, R. Rustgi, Prog. Polym. Sci. 23 (1998) 1273-1335.
[2] R.W.J. Westerhout, J. Waanders, J.A.M. Kuipers, W.P.M. van Swaaij, Ind. Eng. Chem. Res. 36
(1997) 1955-1964.
[3] H. Bockhorn, A. Hornung, U. Hornung, D. Schawaller, J. Anal. Appl. Pyrolysis. 48 (1999) 93-109.
[4] H. Bockhorn, A. Hornung, U. Hornung, J. Anal. Appl. Pyrolysis. 50 (1999) 77-101.
[5] C.H. Wu, C.Y. Chang, J.L. Hor, S.M. Shih, L.W. Chen, F.W. Chang, Waste Management. 13 (1993)
221-235.
[6] G. Manos, A. Garforth, J. Dwyer, Ind. Eng. Chem. Res. 39 (2000) 1203-1208.
[7] G. Manos, A. Garforth, J. Dwyer, Ind. Eng. Chem. Res. 39 (2000) 1198-1202.
[8] G. Manos, Y.I. Yusof, N. Papayannakos, H.N. Gangas, Ind. Eng. Chem. Res. 40 (2001) 2220-2225.
[9] G. Manos, Y.I. Yusof, N. Papayannakos, H.N. Gangas, Energy Fuels. 16 (2002) 485-489.
[10] K. Gobin, G. Manos, Polym. Degrad. Stab. 83 (2004) 267-279.
[11] D.W. Park, E.Y. Hwang, J.R. Kim, J.K. Choi, Y.A. Kim, H.C Woo. Polym. Degrad. Stab. 65 (1999)
193-198.
[12] J.M. Arandes, J. Erena, M.J. Azkoiti, D. Lopez-Valerio, J. Bilbao, Fuel Processing Technology. 85
(2004) 125-140.
[13] H. Ohkita, R. Nishiyama, Y. Tochihara, T. Mizushima, N. Kakuta, Y. Morioka, A. Ueno, Y. Namiki,
S. Tanifuji, H. Katoh, H. Sunazyka, R. Nakayama, T. Kuroyanagi, Ind. Eng. Chem. Res. 32 (1993)
3112-3116.
[14] A.R. Songip, T. Masuda, H. Kuwahara, K. Hashimoto, Applied. Catalysis B Environmental. 2 (1993)
153-164.
[15] J. Arguado, J.L. Sotelo, D.P. Serrano, J.A. Calles, J.M. Escola, Energy Fuels. 11 (1997) 1225-1231.
[16] R.C. Mordi. R. Field, J. Dwyer, J. Anal. Appl. Pyrolysis. 29 (1994) 45-55.
[17] W.C. McCaffrey, M.R. Kamal, D.G. Cooper. Polym. Degrad. Stab. 47 (1995) 133-139.
[18] K.Gobin, G. Manos. Polym. Degrad. Stab. 86 (2004) 225-231.
[19] G.J.T. Fernandes, V.J. Fernandes, Jr., A.S. Araujo. Catalysis Today 75 (2002) 233-238.
[20] L. B. Pierella, S. Renzini, O.A. Anunziata, Microporous and Mesoporous Materials 81 (2005) 155-
159.
[21] J.I. Won Park, J.H. Kim, G. Seo, Polym Degrad Stab. 76 (2002) 495-501.
[22] I.C. Neves, G. Botelho, A.V. Machadob, P. Rebelo. Materials Chemistry and Physics 104 (2007) 5-
9.
[23] K. Gobin, G. Manos. Polym. Degrad. Stab. 83 (2004) 267-279.
[24] A. Durmuş, S. Naci Koç, G. Selda Pozan, A. Kaşgöz, Applied Catalysis B: Environmental. 61
(2005) 316-322.
[25] C. D. Doyle, J. Appl. Polym. Sci. 6 (1962) 639-642.
M.T. Taghizadeh et al. / J. Iran. Chem. Res. 2 (2009) 195-210
210
[26] A. Marcilla, R. Ruiz-Femenia, J. Hernandes, J. Anal. Appl. Pyrolysis. 76 (2006) 254-259.