Optimization of die geometry for Tube Channel Pressing

Journal of Advanced Materials and Processing

مقاله 4، دوره 6، شماره 1، خرداد 2018، صفحه 21-28   

نوع مقاله: Research Paper

نویسنده

Mohammad Hassan Farshidi^*

Department of Metallurgical and Materials Engineering, Ferdowsi University of Mashhad, Mashhad, Iran

چکیده

Since tubes have numerous industrial applications, different attempts are focused on the Severe Plastic Deformation (SPD) processes of tubes. As an illustration, Tube Channel Pressing (TCP) is an attractive process for this purpose since it can be used for processing of different sizes of tubes. However, more attempts are needed to improve the outcomes of TCP. For example, imposing of greater strain besides reductions of strain heterogeneity are the challenges of this process. This work is aimed to optimize the die geometry of TCP in order to increase imposed strain as well as to decrease strain heterogeneity through an FEM simulation method verified by experiment. Results show that the increase of die curvature radius causes decrease of imposed plastic strain and increase of strain heterogeneity. In addition, the minimum amount of die convex height for imposing of reasonable strain through TCP is calculated considering tube thickness and channel angle. Besides this, the optimum die geometry is recommended in order to minimize the strain heterogeneity.

کلیدواژه‌ها

Severe Plastic Deformation؛ FEM simulation؛ Strain analysis؛ Die design