Evaluation of uniform delivery of colloidal nano-Silica stabilizer to liquefiable silty sands

International Journal of Nano Dimension

مقاله 7، دوره 6، شماره 5، اسفند 2015، صفحه 501-508   

نوع مقاله: Reasearch Paper

شناسه دیجیتال (DOI): 10.7508/ijnd.2015.05.007

نویسندگان

Gh. Moradi¹؛ Sh. Seyedi^{* 2}

¹Associate Professor, Faculty of Civil Engineering, University of Tabriz, Tabriz, Iran

²Ph.D. Candidate, Faculty of Civil Engineering, University of Tabriz, Tabriz, Iran

چکیده

Liquefaction is one of the most important and complex topics in geotechnical earthquake engineering. In recent years, passive site stabilization method has been proposed for non-disruptive mitigation of liquefaction risk at developed sites susceptible to liquefaction using colloidal nano-silica stabilizer. In this research, 4 box models were used to investigate the ability to uniformly deliver colloidal nano-silica stabilizer to liquefiable loose mixes of sand with variations in silt content from 0 to 30% using 5 low-head injection and 2 extraction wells. After delivery was completed the models were cured for 30 days. Then the treated soil was excavated and a few samples were extracted for dynamic loading testing. According to the results, colloidal silica can be delivered uniformly in silty sand formations. With the same conditions, the amount of fine grained soil (silt content) strongly affected delivery time. The passive stabilization method can be appropriate for deposits with up to 20% fine graded silt, a concentration of 5 wt% colloidal silica is expected to be able to effectively mitigate the liquefaction risk of these deposits. The strains during seismic cyclic loading will probably be less than 3% and little permanent strain should result.

کلیدواژه‌ها

Colloidal nano-silica؛ Earthquake؛ Liquefaction؛ physical model؛ Silty sand؛ Stabilization

مراجع

[1]  Gallagher P. M., (2000), Passive site remediation for mitigation of liquefaction risk. Ph.D Dissertation, Virginia Polytech. Inst. and State Uni., Blacksburg.

[2]  Gallagher P. M., Koch, A. J., (2003), Model testing of passive site stabilization: A new technique. Proc.3rd Int. Conf. on Grouting and Ground Treatment, New Orleans2: 1478-1490.

[3]  Yonekura, R., Miwa M., (1993), Fundamental properties of Sodium Silicate based grout. Proc.11th Southeast Asia Geotech. Conf. Singapore. 439-444.

[4]  Whang, J. M., (1995), Chemical Based Barrier Materials. In Assessment of Barrier Containment Technologies for Environmental Remediation Applications ( Rumer RR, Mitchel Jk, Editors). Section 9, Springfield, VA: National Technical Information Service.

[5]  Iler R. K., (1979), The Chemistry of Silica: Solubility, Polymerization Colloid and Surface Properties, and Biochemist Try. New York : Wiley. [6] Yonekura R., Kaga M., (1992), Current chemical grout engineering in Japan. In R.H. Borden (Ed.), Grouting, soil improvement and geosynthetics. (725-736). New York: ASCE.

[7]  Persoff P., Apps J., Moridis G., Whang J. M., (1999), Effect of dilution and contaminants on sand grouted with colloidal silica. J. Geotech. Geoenvironment. Engng. 125: 461-469.

[8]  Towhata I., Kabashima Y., (2001), Mitigation of seismically-induced deformation of loose sandy foundation by uniform permeation grouting. Proc. Earthquake Geotech. Engng. Satellite Conf., 15th Int.Conf. of Soil Mech. And Geotech. Enginng, Istanbul. 313-318.

[9]  Gallagher P. M., Mitchell J. K., (2002), Influence of colloidal silica grout on liquefaction potential and cyclic undrained behavior of loose sand. Soil Dynamics and Earthq. Engng. 22: 1017-1026.

[10] Liao H. J., Huang C. C., Chao B. S., (2003), Liquefaction resistance of a colloidal silica grouted sand. In L. F. Johnsen et al. (Ed.), Grouting and grout and deep mixing (1305-1313). Proceeding of the Third International Conference. New Orleans, L. A. Reston, V.A: ASCE.

[11] Diaz-Rodriguez J. A., Antonio-Izarras V. M., Bandini P., Lopez-Molina J. A., (2008), Cyclic strength of natural liquefiable sand stabilized with colloidal silica grout. Canadian Geotech. J. 45: 1345-1355.

[12] Gallagher P. M., Finstere S., (2004), Physical and numerical model of colloidal silica injection for passive site stabilization. Vadose Zone J. 3: 917-925.

[13] Gallagher P. M., Pamuk A., Abdun T., (2007), Stabilization of liquefiable soils using colloidal silica. J. Mater. Civil Eng. 33: 33-40.

[14] Pamuk A., Gallagher P. M., Zimmie T. F., (2007), Remediation of piled foundations against lateral spreading by passive site stabilization technique. Soil Dynamic and Earthq. Eng. 27: 864.874.

[15] Gallagher P. M., Lin Y., (2009). Colloidal silica transport through liquefiable porous media. J. Geotech. Geoenvironmen. Engng. 135: 1702.1712.

[16] Hamderi M., (2010), Pilot scale modeling of colloidal silica delivery to liquefiable sand. Ph.D dissertation, Drexel University. USA.

[17] Moridis G. J., Apps J., Persoff P., Myer L., Muller S., Yen P., Pruess K., (1996), Afield test of a waste containment technology using a new generation of injectable barrier liquids. Spectrum 96, Seattle, WA.

[18] Noll M. R., Bartlett C., Dochat T. M., (1992), In situ permeability reduction andchemical fixation using colloidal silica. Proceedings of the Sixth National Outdoor Action Conference (443.57). Las Vegas, NV.

[19] Gallagher P. M., Conlee C. T., Kyle M., (2007). Full scale testing of colloidal silica grouting for mitigation of liquefaction risk. J. Geotech. Geoenvironment. Engng. 133: 186-196.

[20] Hamderi M., Gallagher P. M., (2013), An optimization study on the delivery distance of colloidal silica. Scientif. Res. Essays. 8: 1314-1323

[21] Hamderi M., Gallagher P. M., Lin Y., (2014), Numerical model for colloidal silica injected column tests. Vadose Zone. J. 13: 138-143.

[22] Seed H. B., Idriss I. M., (1982), Ground motions and soil liquefaction during earthquakes. Berkeley, CA: Earthquake Engineering Research Institute.