Effect of nonionic surfactant additives on the performance of nanofluid in the heat exchanger

International Journal of Nano Dimension

مقاله 3، دوره 8، شماره 1، خرداد 2017، صفحه 18-30   

نوع مقاله: Reasearch Paper

شناسه دیجیتال (DOI): 10.22034/ijnd.2017.24373

نویسندگان

Gajanan P Lakhawat¹؛ Rajendra P Ugwekar²؛ Sanvidhan G Suke^{* 3}؛ Vivek M Nanoti⁴

¹Department of Chemical Engineering, Priyadarshini Institute of Engineering and Technology, Nagpur-440 019 (M.S.), India

²Department of Chemical Engineering, Laxminarayan Institute of Technology, Nagpur-440 033 (M.S.), India

³Department of Biotechnology, Priyadarshini Institute of Engineering and Technology, Nagpur-440 019 (M.S.), India

⁴Department of Physics, Priyadarshini Institute of Engineering and Technology, Nagpur-440 019 (M.S.), India

چکیده

A nanofluid is mixture of nano sized particles and a base fluid. This paper investigates by using laboratory based double pipe heat exchanger model, the performance of nanofluid containing about 48.46nm  particle size nanoparticles (ZnO) without or with addition of nonionic surfactant Rokanol K7 (500ppm) into the base fluid double distilled water to prepared three different concentrations 1.0%, 2% and 3% (v/v) of ZnO-water or ZnO-RK7. Effects of temperature and concentration of nanoparticles on viscosity and heat transfer coefficient in heat exchanger are investigated. The experimental results shows that the viscosity of nanofluids increased with increasing concentration of fluid whereas decreased with increasing temperature from 20 to 60ºC. However, it has been also observed that heat transfer coefficient increases with the operating temperature and concentration of nanoparticles. The conclusion derived for the study is that overall heat transfer coefficient enhanced with increasing concentration upto 3% of ZnO-RK7 as compared to without surfactant nanofluids.

کلیدواژه‌ها

heat exchanger؛ Heat Transfer Coefficient؛ nanofluid؛ Nonionic surfactant؛ Viscosity

مراجع

[1] Sundar L. S., Singh M. K., Venkata Ramana E., Singh B., Grácio J. M., Sousa A. C., (2014), Enhanced thermal conductivity and viscosity of nanodiamond-nickel nanocomposite nanofluids.  Sci. Rep.  4: 4039-4044.

[2] Rahimi-Gorji M., Pourmehran O., Hatami M., Ganji D. D., (2015), Statistical optimization of microchannel heat sink (MCHS) geometry cooled by different nanofluids using RSM analysis. Eur. Phys. J. Plus. 130: 22-26.

[3] Domairry G., Hatami M., (2014), Squeezing Cu–water nanofluid flow analysis between parallel plates by DTM-Padé Method. J. Mol. Liq. 193: 37-44.

[4] Mohammad M., Sadeghinezhad E., Tahan Latibari S., Kazi S. N., Mehrali M., Zubir M. N., Metselaar H. S., (2014), Investigation of thermal conductivity and rheological properties of nanofluids containing graphene nanoplatelets. Nanoscale Res. Lett. 9: 1-12.

[5] Hatami M., Ganji D. D., (2014), Natural convection of sodium alginate (SA) non-Newtonian nanofluid flow between two vertical flat plates by analytical and numerical methods numerical methods. Case Stud. Therm. Eng. 2: 14–22.

[6] Angue Minsta H., Roy G., Nguyen C. T., Doucet D., (2009), New temperature and conductivity data for water-based nanofluids. Int. J. Therm. Sci. 48: 363-371.

[7] Ahmadi A. R., Zahmatkesh A., Hatami M., Ganji D. D., (2014), A comprehensive analysis of the flow and heat transfer for a nanofluid over an unsteady stretching flat plate. Powder Tech. 258: 125-133.

[8] Peng H., Ding G., Hua H., (2011), Effect of surfactant additives on nucleate pool boiling heat transfer of refrigerant-based nanofluid. Exp. Therm. Fluid Sci. 35: 960-970.

[9] Yu W., Xie H., (2012), A Review on nanofluids: Preparation, stability mechanisms, and applications. J. Nanomater. 17: 35873-35878.

[10] Talam S., Karumuri S. R., Gunnam N., (2012), Synthesis, characterization, and spectroscopic properties of ZnO Nanoparticles. ISRN Nanotechnol.  6: 372505-372509.

[11] Aghayari R, Maddah H., Zarei M., Dehghani M., Kaskari Mahalle S. G., (2014), Heat Transfer of Nanofluid in a Double Pipe Heat Exchanger. Int. Scholarly Res. Notices. Article ID 736424: 7.

[12] Pak B. C., Cho Y. I., (1998), Hydrodynamic and heat transfer study of dispersed fluids with submicron metallic oxide particles. Exp. Heat Transfer. 11: 151–170.

[13] Xuan Y., Roetzel W., (2000), Conceptions for heat transfer correlation of nanofluids. Int. J. Heat Mass Transf. 43: 3701–3707.

[14] Einstein A., (1906), A new determination of molecular dimensions. Ann. Der. Phy. 19: 289-306.

[15] Yu W., Choi S. U. S., (2003), The role of interfacial in the enhancemened thermal conductivity of nanofluid: A renovated Maxwell model. J. Nanopart. Res. 5: 167-171.

[16] Lotfi R., Rashidi A. M., Amrollahi A., (2012), Experimental study on the heat transfer enhancement of MWNT-water nanofluid in a shell and tube heat exchanger. Int. Commun. Heat Mass Transf. 39: 108-111.

[17] Siva Kumar S., Venkateswarlu P., Rao V. R., Rao G. N., (2013), Synthesis, characterization and optical properties of Zinc Oxide nanoparticles. Int. Nano Let. 3: 30-36.

[18] Chang H., Tsai M. H., (2008), Synthesis and characterization of ZnO nanoparticles having prism shape by a novel gas condensation process. Rev. Adv. Mater. Sci. 18: 734–743.

[19] Zhou J., Zhao F., Wang Y., Zhang Y., Yang L., (2007), Size controlled synthesis of ZnO nanoparticles and their photoluminescence properties. J. Luminescence. 122-123: 195–197.

[20] Khoshhesab Z. M, Sarfaraz M., Asadabad M. A., (2011), Preparation of ZnO nanostructures by chemical precipitation method, Synthesis and Reactivity in Inorganic. Metal-Organic and Nano-Metal Chem. 41: 814-819.

[21] JCPDS, (1977), Powder diffraction file, alphabetical index, inorganic compounds, international centre for diffraction data, Newtown Square, Pa, USA.

[22] Cullity B. D., (1967), Elements of X-Ray diffraction, addison-wesley, reading, Mass, USA, 3rd edition.

[23] Wen D., Ding Y., (2005), Experimental investigation into the pool boiling heat transfer of aqueous based c-alumina nanofluids. J. Nanopart. Res. 7: 265-274.

[24] Yang Y. M., Maa J. R., (2001), On the criteria of nucleate pool boiling enhancement by surfactant addition to water. Trans. Inst. Chem. Eng. 79(Part A): 409-415.

[25] Wen D. S., Wang B. X., (2002), Effects of surface wettability on nucleate pool boiling heat transfer for surfactant solutions. Int. J. Heat Mass Transf. 45: 1739-1747.

[26] Hetsroni G., Gurevich M., Mosyak A., Rozenblit R., Segal Z., (2004), Boiling enhancement with environmentally acceptable surfactants. Int. J. Heat Fluid Flow. 25: 841-848.

[27] Kole M., Dey T. K., (2010), Thermal conductivity and viscosity of Al₂O₃ nanofluid based on car engine coolant.  J. Phys. D: Appl. Phys. 43: 315501-315505.

[28] Suganthi K. S., Anusha N., Rajan K. S., (2013), Low viscous ZnO–propylene glycol nanofluid: A potential coolant candidate. J. Nanopart. Res. 15: 1986-1989.

[29] Suganthi K. S., Vinodhan V. L., Rajan K. S., (2014), Heat transfer performance and transport properties of ZnO–ethylene glycol and ZnO–ethylene glycol–water nanofluid coolants. Appl. Energy.  135: 548-559.

[30] Wang X., Mujumdar A. S., (2007), Heat transfer characteristics of nanofluids: A review. Int. J. Therm. Sci. 46: 1-19.

[31] Malvandi A, Ganji D. D., (2014), Brownian motion and thermophoresis effects on slip  flow of alumina/water nanofluid inside a circular microchannel in the presence of a magnetic field. Int. J. Therm. Sci. 84: 196-206.

[32] Shoghl S. N., Bahrami M., (2013), Experimental investigation on pool boiling heat transfer of ZnO, and CuO water-based nanofluids and effect of surfactant on heat transfer coefficient. Int. Commun. Heat Mass Transf. 45: 122-129.

[33] Albadr J., Tayal S., Alasadi M., (2013), Heat transfer through heat exchanger using Al₂O₃ nanofluid at different concentrations. Case Studies Therm. Eng. 1: 38-44.