Investigation of Distance Relay Performance in Presence of Resistive ‎Bridge-Type Fault Current Limiter (RBFCL)‎

Journal of Applied Dynamic Systems and Control

مقاله 3، دوره 2، شماره 2، اسفند 2019، صفحه 29-34   

نوع مقاله: Original Article

نویسندگان

Amangaldi Koochaki^* ؛ Mani Khorasaninezhad

Department of Electrical Engineering, Aliabad Katoul Branch, Islamic Azad University, Aliabad Katoul,Iran ‎

چکیده

Due to the development of fault current limiters (FCLs) for employment in high voltage (HV) level power system, the possibility of utilizing them in transmission systems has increased. Installation FCLs have significantly advantages to flexible and reliable operation of power system. Despite the more advantages of installation FCLs, it affects on the transmission lines protection system, which is commonly protected with distance relays.FCLs change the impedance of  transmission lines during fault, which can lead to failure operation of distance relay. In this work, the effect of resistive bridge-type fault current limiter (RBFCL) on the apparent impedance seen by distance relay is investigated. For achieve this, first, the RBFCL is modeled in PSCAD/EMTDC and then the effect of its impact on the distance relay characteristic is evaluated. To this study different short circuit fault including single line to ground (SLG) and line to line (LL) faults are taken in to account. Simulation results reveal the adverse impact of the RBFCL on distance relay performance.

کلیدواژه‌ها

Restive Bridge-Type Fault Current Limiter (RBFCL)؛ Transmission Lines؛ Distance Relay Characteristic

مراجع

[1] D. K. Park, S. E. Yang, Y. S. Yoon, M. C. Ahn, H. M. Kim, Y. S. Kim, J. W. Park and T. K. Ko, “Analysis of the operational characteristics of a resistive SFCL by using the YBCO coated conductor,” IEEE Trans. Appl. Supercond., vol. 17, no. 2, pp. 1851-1854, Jun. 2007

[2] Radmanesh H, Fathi H, Gharehpetian G B.  “Series Transformer-Based Solid State Fault Current Limiter,”IEEE Trans. Smart Grid, vol.6, no.4,pp.1-1, July. 2015.

[3] P. G. Slade et al., “The Utility Requirements for a Distribution Fault Current Limiters,” IEEE Trans. Power Delivery, Vol. 7, No. 2, pp. 507–515, April 1992.

[4] CIGRE WG A3.10: “Fault Current Limiters in High Electrical Medium and Voltage Systems”, CIGRE Technical Brochure, No. 239, 2003.

[5] Hector G.Sarmiento, R.Pampin, “An Example in Controlling Short Circuit Levels in Large Metropolitan Area,” Power Engineering Society General Meeting, IEEE, Vol.2, June 2003

 [6] Mukhopadhyay S C, Dawson F P, Iwahara M, et al.  “A novel compact magnetic  current  limiter  for  three  phase  applications,”  IEEE  Trans. Magn, vol.36, no.5, p.3568-3570, Sep. 2000.

 [7] N. Singh, R. M. Tumilty, G. M. Burt,  C. G. Bright, C. C. Brozio,D. A .Roberts, A. C. Smith, M. Husband “System-Level Studies of a MgB2 Superconducting Fault-Current Limiter in an Active Distribution Network,” IEEE Trans. Appl. Supercond., Vol. 20, No. 2, April 2010.

[8] Radmanesh H, Fathi H, Gharehpetian G B.  “Series Transformer Based Solid State Fault Current Limiter,” IEEE Trans. Smart Grid, vol.6, no.4,pp.1-1, July. 2015.

[9] Moscrop  J  W.  “Experimental  Analysis  of  the  Magnetic  Flux Characteristics of Saturated Core Fault Current Limiters,”  IEEE Trans. Magn., vol.49, no.2, pp. 874-882, Feb. 2013

[10] E. Ro Lee, S. Lee, Ch. Lee, H. Jun Suh, “Test of DC Reactor Type Fault Current Limiter Using SMES Magnet for Optimal Design,” IEEE Trans. Appl. supercond., Vol. 12, No. 2, March 2002

[11]  K. Arai, H. Tanaka, M. Inaba, H .Arai, T. Ishigohka, M. Furuse, and M. Umeda, “Test of Resonance-Type Superconducting Fault Current Limiter,” IEEE Trans. Appl. Supercond., Vol.16, No. 2, June 2006

[12]T. Ise, N. H. Nguyen and S. Kumagai, “Reduction of Inductance and Current Rating of the Coil and Enhancement of Fault Current Limiting Capability of a Rectifier Type Superconducting Fault Current Limiter ,” Trans. Appl. Superconduct., Vol. 16, No. 2, June 2006.

[13] S. Y. Kimi, J. O. Kim, I.S. Bae, and J. M. Cha, “Distribution Reliability Evaluation Affected by Superconducting Fault Current Limitera,” IEEE/PES Transmission and Distribution Conference and Exposition, Latin America, 2010

[14] M. Firouzi, G. B. Gharehpetian, and M. Pishvaei, “THD Reduction of PCC Voltage by Using the Bridge-Type FCL,” Euro. Trans. Electr. Power, 2012

[15] H. Seo, C. Kim, S. Rhee, J. Kim, and O. B. Hyon, “Superconducting Fault Current Limiter Application for Reduction of the Transformer Inrush Current: A Decision Scheme of t he Optimal Insertion Resistance,” IEEE Trans. Appl. Supercond., Vol. 20, No. 4, Agust 2010.

[16] N. Singh, R. M. Tumilty, G. M. Burt,  C. G. Bright, C. C. Brozio,D. A .Roberts, A. C. Smith, M. Husband “System-Level Studies of a MgB2 Superconducting Fault-Current Limiter in an Active Distribution Network,” IEEE Trans. Appl. Supercond., Vol. 20, No. 2, April 2010.

[17] Y. Shirai, K. Furushiba, Y. Shouno, M. Shiotsu and T. Nitta, Y. Shirai, and M. Taguchi,“Improvement of Power System Stability by Use of Superconducting Fault Current Limiter With Zno Device and Resistor in Parallel ,” IEEE Trans on Appl. Superconduct., Vol.18, No.2, March 2008

[18] Firouzi  M,  Gharehpetian  GB,  Mozafari  B.  Bridge-type  superconducting  fault  current  limiter  effect  on  distance relay characteristics. International Journal of Electrical Power & Energy  Systems. 2015; 68:115– 556

[19] Sahebi  A,  Samet  H,  Ghanbari  T.  Method  to  secure the  performance  of  the  differential  protection  in  presence  of  fault  current  limiter  applied  into  the  neutral  line.  IET  Science,  Measurement  &  Technology.  2016; 10(8):880–8. DOI: 10.1049/iet-smt.2016.0119. 

[20] Elmitwally A, Gouda E, Eladawy S. Restoring recloser-fuse coordination by optimal fault current limiters  planning  in  DG-integrated  distribution  systems.  International  Journal  of  Electrical  Power  &  Energy  Systems. 2016; 77:9–18. DOI: 10.1016/j.ijepes.2015.11.021.

[21] A. G. Phadke, T. Hlibka, and M. Ibrahim, “Fundamental basis for distance relaying with symmetrical components,” IEEE Trans. Power App. Syst., vol. PAS-96, pp. 635–646, Mar./Apr. 1977.

[22] D. L. Waikar, S. Elangovan, and A. C. Liew, “Fault impedance estimation algorithm for digital distance relaying),” IEEE Trans. Power Delivery, vol. 9, no. 3, pp. 1375–1383, Jul. 1994.