Investigation of post-annealing effect on efficient ohmic contact to ZnO thin film using Ti/Al metallization strategy

International Journal of Nano Dimension

مقاله 10، دوره 11، شماره 2، تیر 2020، صفحه 199-204   

نوع مقاله: Short Communication

نویسندگان

Vikram Teja؛ Argha Sarkar^* ؛ Padarthi Venkataramana

Nanoelectronics Lab, Sree Vidyanikethan Engineering College, Tirupati, 517102, India.

چکیده

Ohmic and Schottky contacts are playing a major role in the field of ZnO based electronics device fabrication. It is seen that several works have been reported on metallization scheme, contacts with this semiconducting material. But, the thickness of semiconducting material and the choosing of substrate still remain imperfect and inefficient for advanced IC technology. To estimate contact resistance, the transmission line method (TLM) is found to be more complex. So, Schottky barrier height (SBH) model is considered to obtain at most accuracy to find Ohmic contact parameters. Herein, the investigation of parameters like barrier height, ideality factor and saturation current at room temperature of very low specific resistance Ohmic contact to ZnO using Ti/Al metallization scheme are performed. The thermal evaporation technique is performed for the deposition of ZnO thin film of 200 nm and Ti (100nm) /Al (100nm). Further, using a vacuum furnace, post-annealing treatment is also done at different temperatures (Four samples of 3000C, 4500C, 6000C and 7000C at a time period of 20 minutes for each temperature). Characterization of the contacts are done through current-voltage (I –V) using a semiconductor parameter analyzer. The parameters like barrier height, ideality factor and saturation current of this metallization scheme are extracted from the current-voltage plot. It is considered that the theory of thermionic emission is the fundamental phenomenon behind carrier transport at the interface. After post annealing, a comparative analysis is done and the deviations in the parameters are analyzed from semi-log current versus voltage plot and Richardson plot.

کلیدواژه‌ها

Barrier Height؛ Ideality Factor؛ Saturation Current؛ SBH؛ ZnO

مراجع

[1]     Yadav A. B., Sannakashappanavar B. S., (2019), True Ohmic contact on RF sputtered ZnO thin film by using the nonalloy Ti/Au metallization scheme. J. Alloy Compd. 770: 701-709.

[2]     Gur E., Tüzemen S., Kilic B., Coşkun C., (2007), High-temperature Schottky diode characteristics of bulk ZnO. J. Phys. Condens. Matter. 19: 196206-196211.

[3]     Girigoswami K., Akhtar N., (2019), Nanobiosensors and fluorescence based biosensors: An overview. Int J. Nano Dimens. 10: 1-17.

[4]     Adl A. H., Ma A., Gupta M., Benlamri M., Tsui Y. Y., Barlage D. W., Shankar K., (2012), Schottky barrier thin film transistors using solution-processed n-ZnO. ACS. Appl. Mater. Interfaces. 4: 1423-1428.

[5]     Khojier K., Savaloni H., Amani E., (2014), Influence of annealing conditions on the crystallographic structure, chemical composition and luminescence of ZnO thin films. Appl. Surf. Sci. 289: 564-570.

[6]     Xu W., Ye Z., Zhou T., Zhao B., Zhu L., Huang J., (2004), Low-pressure MOCVD growth of p-type ZnO thin films by using NO as the dopant source. J. Cryst. Growth. 265: 133-136.

[7]     Oh D. C., Park S. H., Goto H., Im I. H., Jung M. N., Chang J. H., Koo K. W., (2009), Influence of heat treatments on electrical properties of ZnO films grown by molecular-beam epitaxy. Appl. Phys. Lett. 95: 151908-151912.

[8]     Yadav A. B., Singh K., Pandey A., Jit S., (2014), Annealing-temperature effects on the properties of ZnO thin films and Pd/ZnO Schottky contacts grown on n-Si (1 0 0) substrates by vacuum deposition method. Superlat. Microst. 71: 250-260.

[9]     Dai Z., Shi F., Zhang B., Li M., hang Z., (2011), Effect of sizing on carbon fiber surface properties and fibers/epoxy interfacial adhesion. Appl. Surf. Sci. 257: 6980-6985.

[10] Yadav A. B., Pandey A., Jit S., (2014), Pd Schottky contacts on sol–gel derived ZnO thin films with nearly ideal Richardson constant. IEEE Electron Device Lett. 35: 729-731.

[11] Khojier K., (2017), Sol-gel spin coating derived ZnO thin film to sense the acetic acid vapor. Int. J. Nano Dimens. 8: 164-170.

[12] Lakshmipriya V., Natarajan B., Jeyakumaran N., Prithivikumaran N., (2014), Effect of annealing and UV illumination on properties of nanocrystalline ZnO thin films. Int. J. Nano Dimens. 5: 479-487.

[13] Mastali N.,  Bakhtiari H., (2014), Investigation on the structural, morphological and photochemical properties of spin-coated TiO^ sub 2^ and ZnO thin films prepared by sol-gel method. Int. J. Nano Dimens. 5: 113-118.

[14] Dastan D,. Banpurkar A.,(2016), Solution processable sol-gel derived titania gate dielectric for organic field effect transistors, J. Mater. Sci. Mater. Electron. 28:  3851-3859.

[15] Dastan D., Londhe P. U., Chaure N. B., (2014), Characterization of TiO₂ nanoparticles prepared using different surfactants by sol–gel method. J. Mater. Sci: Mater. Electron. 25: 3473–3479.

[16] Yin X. T., Dastan D., Wu F. Y., Li J., (2019), Facile synthesis of SnO₂/LaFeO₃−XNX composite: Photocatalytic activity and gas sensing performance. Nanomater. 9: 1163-1169.

[17] Abbasi S., Hasanpour M., Ahmadpoor F., Sillanpää M., Dastan D., Achour A., (2019), Application of the statistical analysis methodology for photodegradation of methyl orange using a new nanocomposite containing modified TiO₂ semiconductor with SnO₂. Int. J. Environ. An. Ch. 1-17.

[18] Jafari A., Alam M. H., Dastan D., Ziakhodadadian S., Shi Z., Garmestani H., Ţălu Ş., (2019), Statistical, morphological, and corrosion behavior of PECVD derived cobalt oxide thin films. J. Mater. Sci. Mater. El. 30: 21185-21198.

[19] Zuo H., Fu W., Fan R., Dastan D., Wang H., Shi Z., (2020), Bilayer carbon nanowires/nickel cobalt hydroxides nanostructures for high-performance supercapacitors. Mater. Lett. 263: 127217-127221.

[20] Yin X. T., Lv P., Li J., Jafari A., Wu F. Y., Wang Q., Garmestani H., (2020), Nanostructured tungsten trioxide prepared at various growth temperatures for sensing applications. J. Alloys Compd. 825: 154105-154109.

[21] Brillson L. J., Lu Y., (2011), ZnO Schottky barriers and Ohmic contacts. J. Appl. Phys. 109: 8-13.