Thermal performance of natural circulation loop filled with Al2O3/Water nanofluid

International Journal of Nano Dimension

مقاله 7، دوره 12، شماره 3، مهر 2021، صفحه 272-278   

نوع مقاله: Reasearch Paper

شناسه دیجیتال (DOI): 10.22034/ijnd.2021.681099

نویسندگان

Praveena Devi Nagireddy^{* 1}؛ Srinivasa Rao Chalamalasetti²؛ Kiran Kumar Kupireddi³

¹Mechanical Engineering Department, SR University, Warangal, Telangana-506371, India.

²Mechanical Engineering Department, Andhra University, Visakhapatnam, Andhra Pradesh, India.

³Mechanical Engineering Department, National Institute of Technology Warangal, Telangana, India.

چکیده

Natural Circulation Loop (NCL) which is also called as a thermosyphon system is the heat transfer loop which uses no pump or external device to drive the loop fluid. In the present paper, a comparative study on thermal characteristics of two loop fluids viz. water and Al₂O₃/water nanofluid is made. Experiments are conducted on in-house designed test rig. Thermo-hydraulic behaviour of loop fluid is presented. Two parameters such as heat input, nanofluid concentration are varied in order to study their individual and combined effects. It is concluded that Al₂O₃/water nanofluid as loop fluid results in higher mass flow rates as compared to the water. Different derived quantities such as Nusselt number and Grashof number are calculated. Quantitative comparison is made between water and Al₂O₃/water nanofluid. Time to reach steady state is reduced by 22 % using Al₂O₃/water nanofluid as loop fluid when compared with water. Mass flow rate and Grashof number of the Al₂O₃/water nanofluid based NCL are enhanced by 6.75% and 26% respectively, when compared with water-based NCL at 1000W heat input. At the heater, the temperature gradient is reduced by 30.2% due to the improved thermal and transport properties of Al₂O₃/water nanofluid when compared with water at 1000 W heat input. As particle concentration increases from 1% to 5%, Nusselt number increases from 10.1 to 20.1, for the heat input of 1000W.

کلیدواژه‌ها

Grashof Number؛ Heat Transfer Enhancement؛ Nanofluid؛ NCL؛ Nusselt Number؛ Thermal Performance

مراجع

1. Vijayan K., (2002), Experimental observations on the general trends of the steady state and stability behaviour of single-phase natural circulation loops. Nucl. Eng. Design. 215: 139–152.
2. Ramezanizade M., Alhuyi Nazari M., Ahmadi M. H., Açikkalp E., (2019), Application of nanofluids in thermosyphons: A review. J. Mol. Liq. 272: 395–402.
3. Nayak K., Gartia M. R., Vijayan P. K.,  (2008), An experimental investigation of single-phase natural circulation behavior in a rectangular loop with Al₂O₃ nanofluids. Exp.  Therm. Fluid Sci. 33: 184–189.
4. Kamyar A., Ong K. S., Saidur R., (2013), Effects of nanofluids on heat transfer characteristics of a two-phase closed thermosyphon. Int. J. Heat Mass Trans. 65: 610–618.
5. Zeinali Heris S., Mohammadpur F., Shakouri A., (2014), Effect of electric field on thermal performance of thermosyphon heat pipes using nanofluids. Mater. Res. Bullit. 53: 21–27.
6. Babu Bejjam R., Kiran Kumar K., Balasubramanian K., (2019), Experimental studies on nanofluid-based rectangular natural circulation loop. J. Therm. Sci. Eng. Appl. 11: 041006.
7. Sundar L., Singh M., Punnaiah V., Sousa A., (2018), Experimental investigation of Al₂O₃/water nanofluids on the effectiveness of solar flat-plate collectors with and without twisted tape inserts. Renew. Energy. 119: 820-833.
8. Misale M., Devia F., Garibaldi P., (2012), Experiments with Al₂O₃ nanofluid in a single-phase natural circulation mini-loop: Preliminary results. Appl. Therm. Eng.  40: 64–70.
9. Doganay S., Turgut A., (2015), Enhanced effectiveness of nanofluid based natural circulation mini loop. Appl. Therm. Eng. 75: 669–676.
10. Praveena Devi N., Srinivasa Rao Ch., Kiran Kumar K., (2018), Suitability of magnetic nanofluid in heat transfer loops. Int. J. Heatd Technol. 36: 195-200.
11. Aghayari R., Maddah H., Baghbani Arani J., Mohammadiun H., Nikpanje E., (2015), An experimental investigation of heat transfer of Fe₂O₃/Water nanofluid in a double pipe heat exchanger. Int. J. Nano Dimens. 6: 517-524.
12. Kheram M. A., (2011), Numerical study on convective heat transfer for water-based alumina nanofluids. Int. J. Nano Dimens. 1: 297-304.
13. Sheikhzadeh G. A., Ebrahim Qomi M., Hajialigol N., Fattahi A., (2013), Effect of  Al₂O₃-water nanofluid on heat transfer and pressure drop in a three-dimensional microchannel.  Int. J. Nano Dimens. 3: 281-288.
14. Ramezani Azghandi O., Maghrebi M., Teymourtash A., (2021), Investigation and optimization of heat transfer coefficient of MWCNTs-Water nanofluids in a plate heat exchanger. Int. J. Nano Dimens. 12: 104-112.
15. Asadikia A., Mirjalily S., Nasirizadeh N., Kargarsharifabad H., (2020), Hybrid nanofluid based on CuO nanoparticles and single-walled Carbon nanotubes: Optimization, thermal, and electrical properties. Int. J. Nano Dimens. 11: 277-289.
16. Kumar R. G., (2009), Steady state analysis of CO₂ based natural circulation loops with end heat exchangers. Appl. Therm. Eng. 29: 1893–1903.