Preparation, Characterization and, Activity of CoMo supported on Graphene for Heavy Naphtha Hydro-desulfurization reaction

Iranian Journal of Catalysis

مقاله 1، دوره 11، شماره 2، شهریور 2021، صفحه 101-111   

نوع مقاله: Articles

نویسندگان

Hameed Hussein Alwan^{* 1}؛ Hasan F. Makki²؛ Tahseen A. Al-Hattab¹

¹Chemical Engineering Department, College of Engineering, University of Babylon, Iraq

²Chemical Engineering Department, College of Engineering, University of Baghdad, Iraq

چکیده

Cobalt and Molybdenum oxides supported on graphene catalyst CoMo/G were prepared then its activity for hydro-desulfurization reaction HDS was examined in this research. The catalyst was characterized by X-ray diffraction XRD, Fourier transform infrared spectroscopy FTIR, and energy dispersive spectroscopy EDS while surface morphology was tested by scanning electronic microscopy SEM and atomic force microscopy AFM. The texture properties (specific surface area and pore volume) are measured by the Brunauer, Emmett and Teller BET method. The catalyst activity investigation was conducted by heavy naphtha HDS reaction in a fixed bed reactor, this study investigated the effect of temperature (250-325) ºC, Liquid Hourly Space Velocity LHSV (3-6) hr^.-1 and hydrogen partial pressure (1-1.3) MPa while gas/oil ratio was kept a constant 50 ml/ml, these variables’ impact was designed and analyzed by Taguchi design of experiment DOE with using MINITAB software. The results showed that sulfur removing percentage SR% increases with both increasing of temperature and hydrogen partial pressure whereas LHSV has the opposite effect on SR%. HDS reaction kinetics parameters were estimated by experiment results employing Levenberg-Marquardt and SPSS software version 20; the results showed the HDS reaction which followed 1.863 order, reaction rate constant and activation energy, is 32.309 kJ/mol. 

کلیدواژه‌ها

Heavy Naphtha؛ CoMo catalyst؛ Graphene؛ hydro desulfurization؛ reaction kinetics؛ Taguchi method؛ Levenberg-Marquardt algorithm

مراجع

[1]. Chen, T.-M.,WG Kuschner, J Gokhale and, S Shofer., Amer. J. Med. Sci., 333(4) , (2007), 249-256.

[2]. S Liu, B Wang, BCui and, L Sun, Fuel, 87(3), (2008), 422-428.

[3]. I. Mohammed, H. H. Alwan, Ghanim A. N, IOP Conference Series: Mater. Sci. Eng. 928, (2020), 022158.

[4]. S Cristol, J F Paul, E Payen, D Bougeard, F Hutschka and, S Clemendot,  J. Catal. 224 (1) (2004), 138-147.

[5]. A Kundu, K.D.P. Nigam, A.M. Duquenne and, H. Delmas, Rev. Chem. Eng., 19 (6), (2003), 531-605.

[6]. Z. Hajjar, M. Kazemeini, A. Rashidi, M. Bazmi, Catal. Let., 145 ( 9)  (2015),1660-1672.

[7]. H. H. Alwan, Ammar A. Ali, and Hassan F. Makki, Bullet. Chem. React. Eng. Catal. 15 ( 1) (2020), 175-185.

[8]. Jéssica Rabelo do Nascimento, Monique Ribeiro D’Oliveira, Amanda Garcez Veiga, Carlos Alberto Chagas, and Martin Schma, ACS Omega , 5 ( 40 )  (2020), 25568-25581.

[9]. Hasan F. Makki and H. H. Alwan,  AAUJES, 26 (1)  (2019), 49-54.

[10]. Shyamal. K. Bej, R. P. Dabral, P. C. Gupta, K. K. Mittal, G. S. Sen, V. K. Kapoor, and Ajay K. Dalai, Energ. Fuels, 14 (3)  (2000), 701-705.

[11]. Z. N. Kayani, S. Arshad, S. Riza, R. Zia and, S. Naseem, JOAM, 11 (12) (2009), 2141-2144.

[12]. Jong-Pil Jegal, Hyun-Kyung Kim, Jeom- S0 Kim and, Kwang -Bum Kim, J.  Electroceram., 31 (1-2)  (2013), 218-223.

[13]. Z. Hajjar, M. Kazemeini, A. Rashidi, M. Bazmi, Fuel, 165 (2016), 468-476.

[14]. T. Wei, Z. Fan, G. Luo, C. Zhang and, D. Xie, Carbon, 47 (1) (2009), 337-339.

[15]. A. T. Bell, Science, 299 (5613) (2003), 1688-1691.

[16]. S. Ki Kim, D. Yoon, S. Cheol Lee and, J. Kim,  ACS Catal., 5 (6),  (2015), 3292-3303.

[17]. James G. Speight, The desulfurization of heavy oils and residua. 1999, second edition,  CRC Press.

[18]. S. Athreya and Dr Y.D.Venkatesh, IRJES ,1 (3)  (2012), 13-19.

[19]. Z. R. Lazic,  Design of experiments in chemical engineering: a practical guide. (2004), John Wiley & Sons.

[20]. C. Yin, R Zhao and Chenguang,  Energ. Fuels , 17 (5) (2003), 1356-1359.

[21]. X. Lan, C. Xu, G. Wang and, J. Gao, Catal. Today 140 (3-4), (2009), 174-178.

[22]. J.V.Lauritsen , M. Nyberg , J.K. Norsjov , B.S. Clausen , H Topsoe , E. Laegssgaard and , F. Bensenbacher ,  J. Catal. 224 ( 1)  (2004) 94-106.

[23]. J. Ancheyta , M.J. Angeles , M .J. Maciad , G. Marroquin and, R. Morales , Energ. Fuels  16 ( 1 ), (2002), 189-193.

[24]. Gopal H. Singhal, Ramon L. Espino, Jay E. Sobal and G.A. Huff, J. Catal. 67 ( 2), (1981), 457-468.

[25]. Syed Tajammul Hussein, F. Zia and M. Mazjar, Eur. Food Res. Tech.,228 ( 5 )  (2009), 799-806.