Simulation and Reduction of Radar Cross Section the Unmanned Aerial Vehicle in X-band Using Shaping Technique

Majlesi Journal of Telecommunication Devices

مقاله 9، دوره 1، شماره 4، فروردین 2012   

نوع مقاله: Articles

نویسندگان

Hamid Heidar¹؛ Naser Moradisoltani^{* 1}؛ Omid Alihemati²

¹Department of Electronics and Communication, Malek-Ashtar University of Technology, Tehran

²Department of Materials, Malek-Ashtar University of Technology, Tehran

چکیده

Radar Cross Section (RCS) reduction is very important factor to increase survivability. This paper used a model of the Unmanned Aerial Vehicle (UAV) will be as a reference and focus on RCS reduction by using shaping methods. Simulation software CST was used to calculate the RCS of aerial targets. Four types of target geometries are simulated to find the final optimal design which will give a less value of RCS compared with the reference geometry over X-Band (8, 9,10,11,12 GHz are used for simulation then average value is drowned).

کلیدواژه‌ها

en

مراجع

[1] D. C. Jenn, Radar and Laser Cross Section Engineering, 2nd ed, AIAA education series, 2005.

[2] N. N. Youssef, “Radar Cross Section of Complex Target, ” IEEE, VOL.77, NO. 5, May 1989.

[3] G. A. and C. Sr, “ The descriptive geometry of nose cone, ” 1996.

[4] I. M. M r n, M. A. Alve , G. G. Pe xo o , nd M. C. Rezende, “Radar Cross Section on Measurement and Simulations of a Model Airplane in the X-b nd, ” PIERS Onl ne, Vol. 5, No. 4, 2009..

[5] CST, EM Software & Systems, Available: http://www.cst.com. Accessed JUNE, 2011.

[6] L. Sevgi, “Radar Cross Section (RCS) prediction techniques: from high frequency asymptotic to numerical simulations, ” University Zeamet Sok., No.2 , Acıb dem Turkey 2 4..

[7] J. M. Rius, M. Ferrando, and L. Jofre, “High-Frequency RCS of Complex Radar Targets in Real-Time, ” IEEE, VOL. 41, NO. 9, September 1993.

[8] Chinn, S.S.; Missile Configuration Design, McGraw-Hill Book Co., Inc, New York, Copyright 1961.

[9] Knott, E. F., J. F. Schaeffer, and M. T. Tuley, Radar Cross Section Measurements, Artech House Inc, Norwood, 1993.

[10] “IEEE Standard Definitions for Terms for

Antennas,” IEEE Trans. On Antennas and

Propagation, vol. AP-37, pp. 956-966, June

1989.