Effects of STATCOM Control Mode on Voltage Stability

Majlesi Journal of Electrical Engineering

مقاله 2، دوره 2، شماره 4، دی 2008   

نوع مقاله: Review Article

شناسه دیجیتال (DOI): 10.1234/mjee.v2i4.133

نویسنده

Ali Zare^*

چکیده

STATCOM is one of the most popular devices that been used for voltage stability. There has been no report on the effect of SATCOM control mode on voltage stability. It is very important to understand which parameters and what value of these parameters affect the voltage stability. The results of previous studies have shown that the STATCOM have considerable effects on the improvement of voltage stability, but there have not been any investigations on the effects of the control mode of STATCOM on the voltage stability. This paper deals with the effect of the STATCOM control mode on voltage stability. Simulation results on the IEEE 30-bus test system show the high effect of the STATCOM control mode on voltage stability. 

کلیدواژه‌ها

Control Mode؛ en؛ Continuation Power Flow؛ STATCOM؛ Voltage stability

مراجع

[1] V.Ajjarapu, Computational Techniques for

Voltage Stability Assessment and Control,

Springer, 2006.

[2] A. Kazemi, V. Vahidinasab, A. Mosallanejad;

“Study of STATCOM and UPFC

controllers for voltage stability evaluated

by saddle-node bifurcation analysis”, First

International Power and Energy Conference,

PECon 2006, Putrajaya, Malaysia, 2006, pp.

191-195.

[3] N.Boonpirom, K.Paitoonwattanakij; “Static

voltage stability enhancement using

FACTS”, The 7th International Power

Engineering Conference, IPEC 2005, 2005,

pp. 711 – 715.

[4] A.Sode-Yome, N.Mithulananthan, K.Y.Lee;

“Static voltage stability margin

enhancement using STATCOM, TCSC and

SSSC” ,IEEE/PES Transmission and

Distribution Conference & Exhibition, Asia

and Pacific, China, 2005, pp.1-6.

[5] X.P.Zhang, C.Rehtanz, B.Pal, Flexible AC

Transmission Systems: Modelling and

Control, Springer, berlin, 2006, pp.189-216.

[6] A. Sode-Yome, N. Mithulananthan, Kwang Y.

Lee, “A Comprehensive Comparison of

FACTS Devices for Enhancing Static

Voltage Stability”, IEEE Power Engineering

Society General Meeting, 24-28 June 2007,

pp. 1 - 8.

[7] A.R. Messina, M.A. Pe´rez, E. Herna´ndez;

“Co-ordinated application of FACTS

devices to enhance steady-state voltage

stability”, International Journal of Electrical

Power & Energy Systems, Vol. 44, Issue 6,

2003, pp. 259–267.

[8] P.Kundur, B.Gao, G.K.Morison; “Voltage

stability evaluation using modal analysis”,

IEEE Trans. On Power Systems, Vol. 7, Issue

4, Nov, 1992, pp.1529 – 1542

[9] F.A.El-Sheikhi, Y.M.Saad, S.O.Osman,

K.M.El-Arroudi; “Voltage stability

assessment using modal analysis of power

systems including flexible AC transmission

system (FACTS) ”, Power Systems

Engineering Conference, 7-9 May, 2003, pp.

105 – 108

[10] J. M.Ramirez, J.L.Murillo-Perez; “Steady-

State Voltage Stability with STATCOM”,

IEEE Trans. on Power Systems, Vol. 21, No.

3, 2006, pp.1453-1454.

[11] W. Zhang, F. Li, L. M. Tolbert, "Optimal

Allocation of Shunt Dynamic Var Source

SVC and STATCOM: A Survey," IEE

International Conference on Advances in

Power System Control, Operation and

Management (APSCOM) October 31 -

November 2, 2006, Hong Kong, China.

[12] Eirini A. Leonidaki, Nikos D. Hatziargyriou,

“Investigation of Decision Trees (DTs)

Parameters for Power System Voltage

Stability Enhancement”, Advances in

Artificial Intelligence, Springer Berlin

Heidelberg, Vol. 3955, 2006.

[13] C.Taylor; “Indices predicating voltage

collapse including dynamic phemomena”

CIGRE Task Force 38.02.11, 1994.

[14] S.Repo, “on-line voltage stability assessment

of power system an approach of black-box

modeling”, M.Sc.dissertation, Dept. Elect.

Eng., tampere university of technology, 2001.

[15] E.Acha, C.R.F.Esquivel, H. A. Pe´rez, C.

A.Camacho; FACTS:Modelling and

Simulation in Power Networks, John Wiley

& Sons, New York, 2004,pp.191-195.

[16] http://www.ee.washington.edu/research/pstca/