Digital Simulation of Fault Tolerant Inverter Fed Induction Motor with a Leg Swap Module

Majlesi Journal of Electrical Engineering

مقاله 7، دوره 6، شماره 2، شهریور 2012   

نوع مقاله: Review Article

نویسندگان

Nagarajan Shola^* ؛ S. Rama Reddy

Jerusalem College of Engineering, EEE Department, Chennai, India

چکیده

Most of the industrial operations involve the use of induction motor drives. The operations of be fault tolerant. This paper investigates the fault operation of a single phase open the drives are so crucial in some events that any fault in the operation of drive could result in serious loss to the industry in terms of capital and raw materials. Hence, it is necessary that an induction motor drive should circuit fault in the drive by performing fault analysis on the harmonic spectrum of the current waveforms. A fault tolerant system is proposed which can operate even after occurrence of the fault in runtime. The simulation studies are done using MATLAB simulation tool and the results are presented.

کلیدواژه‌ها

en

مراجع

[1] Benbouzid M.E.H (2000), “A Review of Induction Motors Signature Analysis as a Medium for Faults Detection,” IEEE Trans. Industrial Electronics, Vol. 47, No. 5, pp. 984 – 993.

[2] William Thomson and Mark Fenger, “Current Signature Analysis to Detect Induction Motor Faults,” IEEE Industry Applications Magazine,pp. 26-34, July/August 2001.

[3] Biswa B.,Das S(2009), “Current Harmonics Analysis of Inverter-Fed Induction Motor Drive System under Fault Conditions, ” in Proc. of the International MultiConference of Engineers and Computer.

[4] Bin Huo and Andrzej M. Trzynadlowski(2001), “Simple Stator Fault Detector for AC Motors, ” IEEE Trans. Industry Applications, Vol.39, pp. 192-194.

[5] Debmalya Banerjee, Ranganathan V. T.(2009), “Load-Commutated SCR Current-Source-Inverter-Fed Induction Motor Drive With Sinusoidal Motor Voltage and Current” IEEE Transactions on Power Electronics, Vol. 24, No. 4.

[6] Don.–H. Hwang, K.–C.Lee, Y. –J. Kim (2003), “Voltage stresses on stator windings of induction motors driven by IGBT PWM inverters”, in Proc. 38th IAS Annual conference, Vol. 1, pp. 439 – 444.

[7] Jee-H Jung, Lee J, and Kwon B (2006), “Online Diagnosis of Induction Motors Using MCSA”, IEEE Trans. Industrial Electronics, Vol. 53, No. 6, pp. 1842 – 1852.

[8] Pereira L. A., Silva Gaz G. da zana, and Pereira L.F (2005), “Motor current signature analysis and fuzzy logic applied to the diagnosis of short-circuit faults in induction motors”, in Proc. 32nd Annual Conference of IEEE Industrial Electronics Society IECON 2005, pp. 6.

[9] Shi K.L.,Chan T.F. and Wong Y.K.(1999), “Modelling And Simulation Of The Three-Phase Induction Motor Using Simulink”, in Proc. Int. J. Elect. Enging. Educ., Vol. 36, pp. 163–172. Manchester U.P.

[10] Andre M. S. Mendes, Xose M. Lopez-Fernandez,and Antonio J. Marques Cardoso(2008), “Thermal Performance of a Three-Phase Induction Motor Under Fault Tolerant Operating Strategies”, in Power Electronics Specialist Conference,Recife-Brazil, 2005,Vol. 23, pp.1537-1544.

[11] Brian A. Welchko, Thomas A. Lipo, ThomasM.Jahns, and Steven E. Schulz, “Fault Tolerant Three-Phase AC Motor Drive Topologies: A Comparison of Features, Cost, and Limitations”, in IEEE International Electric Machines and Drives Conference, Madison, WI, 2003,Vol. 19, pp. 1108-1116.

[12] M.A.Rodriguez, A.Claudio, D.Theilliol, L.G.Vela, L.Hernandez(2009), “Strategy to replace the Damaged Power Device for Fault Tolerant Induction Motor Drive” 978-1-422-2812-0/09/IEEE.