Sensing Behavior Study of Manganese Zinc Ferrite Nanoparticles Against Carbon Tetrachloride at Various Temperatures

Majlesi Journal of Electrical Engineering

مقاله 10، دوره 16، شماره 3، آذر 2022، صفحه 85-89   

نوع مقاله: Reseach Article

شناسه دیجیتال (DOI): 10.30486/mjee.2022.696509

نویسندگان

Gholam Reza Aboutalebi¹؛ Hamid Reza Ebrahimi^{* 2}؛ Hossein Emami³؛ Saeid Daneshmand⁴؛ Gholam Reza Amiri⁵

¹Department of Electrical Engineering, Majlesi Branch, Islamic Azad University, Majlesi, Isfahan 9631656769, Iran.

²Advanced Engineering Research Center, Majlesi Branch, Islamic Azad University, Majlesi, Isfahan, Iran

³Department of Electrical Engineering, Majlesi Branch, Islamic Azad University, Majlesi, Isfahan 9631656769, Iran

⁴Department of Mechanical Engineering, Majlesi Branch, Islamic Azad University, Majlesi, Isfahan 9631656769, Iran

⁵Department of Physics, Falavarjan Branch, Islamic Azad University, Isfahan, Iran

چکیده

In this study, zinc ferrite nanoparticles with a diameter of less than 50 nm were synthesized. Using XRD (X-ray Diffraction), Scanning Electron Microscope (SEM) and Transmission Electron Microscope (TEM) the morphology and structure of this ferrite was investigated. The formation of spinel phase in Zn-Mn ferrite was shown by X-ray analysis. SEM photograph has shown spherical shape of nanoparticles and the dimensions of the samples were confirmed by Transmission Electron Microscope (TEM) at the nanoscale. Using the Debye-Scherrer formula, the size of Mn ferrite nanoparticle crystals was calculated to be about 13 nm. To check the properties related to the sensitivity of this ferrite, a fully insulated Plexiglass box was used and placed in it. By injecting 1 mL of liquid and vapor it, we will have 200 ppm concentration of each sample in this box. Then the injected vapored sample in this box is exposed to the ferrite. After this step, the conductivity of the ferrite in a closed circuit was changed. By changing the sample type, amount of this conductivity was varied. Five gases were tested in this project: ethanol, dimethyl formamid, carbon tetrachloride, acetonitrile and acetone. Among these samples the carbon tetrachloride had the best sensitivity performance. Finally, the sensor equation for carbon tetrachloride was extracted by applying different concentrations of it from 20 to 200 ppm.

کلیدواژه‌ها

Carbon Tetrachloride Sensor؛ Ferrite؛ Gas Sensor؛ Manganese Zinc Ferrite Nanoparticle؛ Sensitivity؛ X–ray Diffraction

مراجع

[1] Huang, X. J., Choi, Y. K., “Chemical sensors based on nanostructured materials.”, Sensor Actuat. B-Chem., 2007, 122, 659–671.

[2] N.V. Hoang, C.M. Hung, N.D. Hoa, N.V. Duy, N.V. Hieu, “Facile on-chip electrospinning of ZnFe2O4 nanofiber sensors with excellent sensing performance to H2S down ppb level”, J. Hazard Mater., 2018, 360, 6–16.

[3] T. Saidi, O. Zaim, M. Moufid, N.E. Bari, R. Ionescu, B. Bouchikhi, “Exhaled breath analysis using electronic nose and gas chromatography-mass spectrometry for non-invasive diagnosis of chronic kidney disease, diabetes mellitus and healthy subjects”, Sens. Actuators, B, 2018, 257, 178–188.

[4] T. Vidya Sagar, T. Subba Rao, K. Chandra Babu Naidu, “AC-electrical conductivity, magnetic susceptibility, dielectric modulus and impedance studies of sol-gel processed nano-NiMgZn ferrites”, Materials Chemistry and Physics, Volume 258, 2021, 123902.

[5] W. -J. Zhao, K. -L. Ding, Y. -S. Chen, F. -Y. Xie and D. Xu, “Optimized Low Frequency Temperature Modulation for Improving the Selectivity and Linearity of SnO2 Gas Sensor,” in IEEE Sensors Journal, vol. 20, no. 18, pp. 10433-10443, 15 Sept.15, 2020.

[6] Zarzycki, A.; Chojenka, J.; Perzanowski, M.; Marszalek, M. “Electrical Transport and Magnetic Properties of Metal/Metal Oxide/Metal Junctions Based on Anodized Metal Oxides”. Materials 2021, 14, 2390.

[7] Gautam Yogendra K., Sharma Kavita, Tyagi Shrestha, Ambedkar Anit K., Chaudhary Manika and Pal Singh Beer, “Nanostructured metal oxide semiconductor-based sensors for greenhouse gas detection: progress and challenges.” 2021.

[8] Fang, C., Li, H., Li, L., Su, H., Tang, J., Bai, X. and Liu, H. (2022), “Smart Electronic Nose Enabled by an All-Feature Olfactory Algorithm.”, Adv. Intell. Syst. 2200074.

[9] Skotadis, E.; Aslanidis, E.; Kainourgiaki, M.; Tsoukalas, D. “Nanoparticles Synthesised in the Gas-Phase and Their Applications in Sensors: A Review.” Appl. Nano 2020, 1, 70-86.

[10] Korotcenkov, G. “Current Trends in Nanomaterials for Metal Oxide-Based Conductometric Gas Sensors: Advantages and Limitations. Part 1: 1D and 2D Nanostructures.”, Nanomaterials 2020, 10, 1392.

[11] Zamiri, G.; Haseeb, A.S.M.A. “Recent Trends and Developments in Graphene/Conducting Polymer Nanocomposites Chemiresistive Sensors.” Materials 2020, 13, 3311.

[12] Wei Wang, Yirui Shu, Hengli Xiang, Dehua Xu, Pan Zhang, Genkuan Ren, Yanjun Zhong, Xiushan Yang, “Magnetic properties of Cu0.5Mg0.5Fe2O4 nanoparticles synthesized with waste ferrous sulfate”, Materials Today Communications, Volume 25, 2020, 101516.

[13] Abdolrahim Yousefi-Darani, Majharulislam Babor, Olivier Paquet-Durand, Bernd Hitzmann, “Model-based calibration of a gas sensor array for on-line monitoring of ethanol concentration in Saccharomyces cerevisiae batch cultivation”, Biosystems Engineering, Volume 198, 2020, Pages 198-209.

[14] Nikolic, M.V.; Milovanovic, V.; Vasiljevic, Z.Z.; Stamenkovic, Z. “Semiconductor Gas Sensors: Materials, Technology, Design, and Application”. Sensors 2020, 20, 6694.

[15] Chen, N. S., Yang, X. J., Liu, E. S., Huang, J. L., “Reducing gas-sensing properties of ferrite compounds MFe2O4 (M=Cu, Zn, Cd and Mg).”, Sensor Actuat. B-Chem., 2000, 66, 178-180.

[16] Kumar, Y., Sharma, A., Shirage, P.M., “Shape-controlled CoFe2O4 nanoparticles as an excellent material for humidity sensing.”, RSC Adv., 2017, 7(88), 55778–55785.

[17] Singh, A., Singh, R., Singh, S., Tandon Yadav, B.C., “Preparation and characterization of nanocrystalline nickel ferrite thin films for development of a gas sensor at room temperature.”, J. Mater. Sci.: Mater. Electron., 2016, 27(8), 8047–8054.

[18] Koli, P.B., Kapadnis, K.H., Deshpande, U.G., “Methanol gas sensing properties of pervoskite LaFeO3 nanoparticles doped by transition metals Cr3+ and Co2+.”, J. Chem. Pharm. Res., 2017, 9(1), 253–259.

[19] Rong, Q., Zhang, Y., Wang, C., Zhu, Z., Zhang, J., Liu, Q., “A high selective methanol gas sensor based on molecular imprinted Ag–LaFeO3 fibers.”, Sci. Rep., 2017, 7, 12110.

[20] Satyanarayana, L., Reddy, K. M., Manorama, S. V., “Synthesis of nanocrystalline Ni1−xCoxMnxFe2− xO4: a material for liquefied petroleum gas sensing. Sensor”, Actuat. B-Chem., 2003, 89, 62-67.

[21] Ladhea, R. D., Guravc, K. V., Pawarb, S. M., Kimc, J. H., Sankapal, B. R., “p-PEDOT: PSS as a heterojunction partner with n-ZnO for detection of LPG at room temperature.”, J. Alloy Compd., 2012, 515, 80–85.

[22] Kadu, A. V., Jagtap, S. V., Chaudhari, G. N., Studies on the preparation and ethanol gas sensing properties of spinel Zn0.6Mn0.4Fe2O4 nanomaterials.”, Current Applied Physics, 2009, 9, 1246–1251.

[23] Singh, A., Singh, S., Joshia, B. D., Shukla, A., Yadav, B. C. Tandon, P., “Synthesis, characterization, magnetic properties and gas sensing applications of ZnxCu1-xFe2O4 (0.0≤x≤0.8) nanocomposites.”, Mat. Sci. Semicon. Proc., 2014, 27, 934–949.

[24] Jain,A., Baranwal, R. K., Bharti, A., Vakil, Z., Prajapati, C. S,. “Study of Zn-Cu Ferrite Nanoparticles for LPG Sensing.”, The Scientific World Journal, Volume 2013, Article ID 790359, 7 pages

[25] Qiaohua, F., Ruru, Z., Xintian, M., Yunbo, S., “Preparation of ZnO Semiconductor Formaldehyde Gas Sensor.”, 2013 2nd International Conference on Measurement, Information and Control.

[26] Köseoglu, Y., Aldemir, I., Bayansal, F., Kahraman, S., Çetinkara, H. A., “Synthesis, characterization and humidity sensing properties of Mn0.2Ni0.8Fe2O4 Nanoparticles.”, Mater. Chem. Phys., 2013, 139, 789-793.

[27] Shan, J., Bougiatioti, P., Liang, L., Reiss, G., Kuschel, T., van Wees, B.J. “Nonlocal magnon spin transport in NiFe2O4 thin films.”, Appl. Phys. Lett., 2017, 110(13), 132406 (1–5).

[28] Chavan, P., Naik, L.R. “Investigation of energy band gap and Conduction mechanism of magnesium substituted nickel ferrite nanoparticles.”, Phys. Status Solid A, 2017, 214(9), 1–8.

[29] Babadi, N., Tavakkoli, H., Afshari, M., “Synthesis and characterization of nanocomposite NiFe2O4@SalenSi and its application in efficient removal of Ni(II) from aqueous solution.”, Bull. Chem. Soc. Ethiop., 2018, 32(1), 77–88.

[30] Pubby, K., Meena, S.S., Yusuf, S.M., Narang, S.B., “Cobalt substituted nickel ferrites via Pechini’s sol–gel citrate route: X-band electromagnetic characterization.”, J. Magn. Magn. Mater., 2018, 466, 430–445.

[31] Ananya Dey, “Semiconductor metal oxide gas sensors: A review”, Materials Science and Engineering: B, Volume 229, 2018, Pages 206-217.

[32] A. Sendi et al., "Performance of MOX Gas Sensors Obtained by Mixing P-Type and N-Type Metal Oxides for Relaible Indoor Air Quality Monitoring," 2019 20th International Conference on Solid-State Sensors, Actuators and Microsystems & Eurosensors XXXIII (TRANSDUCERS & EUROSENSORS XXXIII), 2019, pp. 1305-1308.

[33] Feng, S.; Farha, F.; Li, Q.; Wan, Y.; Xu, Y.; Zhang, T.; Ning, H. “Review on Smart Gas Sensing Technology.” Sensors 2019, 19, 3760.

[34] Ali Mirzaei, Jae-Hyoung Lee, Sanjit Manohar Majhi, Matthieu Weber, Mikhael Bechelany, Hyoun Woo Kim, and Sang Sub Kim, "Resistive gas sensors based on metal-oxide nanowires", Journal of Applied Physics 126, 241102 (2019)