Modified Sawdust as an Efficient Adsorbent for the Removal of Eosin Y Dye: Optimization, Isotherm, Regeneration of Adsorbent, and Real Sample Studies

Journal of Chemical Health Risks

مقالات آماده انتشار، پذیرفته شده، انتشار آنلاین از تاریخ 27 آبان 1402   

نوع مقاله: Original Article

شناسه دیجیتال (DOI): 10.22034/jchr.2023.1930392.1307

نویسندگان

Leila Afrasiyabi¹؛ Shahla Elhami^{* 2}؛ Rostam Shabani¹

¹Department of Chemistry, Firouzabad Branch, Islamic Azad University, Firouzabad, Iran

²Department of Chemistry, Ahvaz Branch, Islamic Azad University, Ahvaz, Iran

چکیده

In the current investigation, the utilization of sawdust was modified through chemical means employing diethylenetriamine. This modified form of sawdust served as an effective adsorbent for the purpose of adsorbing Eosin Y dye from aqueous samples. The chemical modification procedure was thoroughly examined, comparing the fourier transform of infrared spectroscopy (FTIR) and scanning electron microscopy (SEM) before and after the modification. Various factors including solution pH (ranging from 2 to 6), adsorbent dosage (ranging from 0.2 to 2.0 g L^-1), contact time (ranging from 5 to 35 min), agitation rate, and initial dye concentration (ranging from 20 to 1000 mg L^-1) were investigated. Remarkably, the modified sawdust exhibited a notable uptake capacity at ambient temperature and successfully removed approximately 96% of the Eosin Y dye with a mere 1.2 g L^-1 of adsorbent in just 5 minutes. Moreover, it was discovered that the adsorbent maintained its promising adsorption ability even after undergoing ten cycles of adsorption and desorption. The Freundlich isotherm model was employed to determine the adsorption parameters. This methodology was also implemented to eliminate dye from authentic samples of diverse water sources.

کلیدواژه‌ها

Adsorption؛ Eosin Y؛ Freundlich isotherm؛ Modified sawdust؛ Removal

مراجع

1. Liu Y., Chen Y., Shi Y., Wan D., Chen J., Xiao S., 2020. Adsorption of toxic dye Eosin Y from aqueous solution by clay/carbon composite derived from spent bleaching earth. Water Environment Research. 93, 159.
2. Chatterjee S., Chatterjee S., Chatterjee B.P., Das A.R., Guha A.K., 2005. Adsorption of a model anionic dye, eosin Y, from aqueous solution by chitosan hydrobeads. Journal of Colloid and Interface Science. 288, 30–35.
3. Mcyotto F., Wei Q., Macharia D.K., Huang M., Shen Ch., Chow Ch.W.K., 2021. Effect of dye structure on color removal efficiency by coagulation. Chemical Engineering Journal. 405, 126674.
4. Mais L., Vacca A., Mascia M., Usai E.M., Tronci S., Palmas S., 2020. Experimental study on the optimisation of azo-dyes removal by photo-electrochemical oxidation with TiO₂nanotubes. Chemosphere. 248, 125938.
5. Shojaei S., Nouri A., Baharinikoo L., Davoodabadi Farahani M., Shojaeid S., 2021. Removal of the hazardous dyes through adsorption over nanozeolite-X: Simultaneous model, design and analysis of experiments. Polyhedron. 196, 114995.
6. Tanzifi M., Tavakkoli Yaraki M., Beiramzadeh Z., Heidarpoor Saremi L., Najafifard M., Moradi H., Mansouri M., Karami M., Bazgir H., 2020. Carboxymethyl cellulose improved adsorption capacity of polypyrrole/CMC composite nanoparticles for removal of reactive dyes: Experimental optimization and DFT calculation. Chemosphere. 255, 127052.
7. Saxena M., Sharma N., Saxena R., 2020. Highly efficient and rapid removal of a toxic dye: Adsorption kinetics, isotherm, and mechanism studies on functionalized multiwalled carbon nanotubes. Surfaces and Interfaces. 21, 100639.
8. Razavi Mehr M., Fekri M.H., Omidali F., Eftekhari N., Akbari-adergani B., 2019. Removal of Chromium (VI) from Wastewater by Palm Kernel Shell-based on a Green Method. Journal of Chemical Health Risks. 9(1), 75-86.
9. Rezaei Ranjbar F., Khamchin Moghadam F., 2020. Removal of Pharmaceutical Pollutions of Aspirin and Atrazine fromWaste Water Using Carbon Nanotubes. Journal of Chemical Health Risks. 10(1), 17-24.
10. Chakraborty S., De S., DasGupta S., Basu J.K., 2005. Adsorption study for the removal of a basic dye:experimental and modeling. Chemosphere. 58, 1079–1086.
11. Shukla A., Zhang Y., Dubey P., Margrave J.L., Shukla, Sh.S., 2002. The role of sawdust in the removal of unwanted materials from water. Journal of Hazardous Materials. 95, 137–152.
12. Garg V.K., Amita M., Kumar R., Gupta R., 2004. Basic dye (methylene blue) removal from simulated wastewater by adsorption using Indian Rosewood sawdust: a timber industry waste. Dyes and Pigments. 63, 243-250.
13. Sidiras D., Batzias F., Schroeder E., Ranjan R., Tsapatsis M., 2011. Dye adsorption on autohydrolyzed pine sawdust in batch and fixed-bed systems. Chemical Engineering Journal. 171, 883-896.
14. Khattria S.D., Singh M.K., 2009. Removal of malachite green from dye wastewater using neem sawdust by adsorption. Journal of Hazardous Materials. 167, 1089–1094.
15. Benyoucef S., Amrani M., 2011. Adsorption of phosphate ions onto low cost Aleppo pine adsorbent. Desalination. 275, 231-236.
16. Zhonga Q., Yue Q., Li Q., Xu X., Gao B., 2011. Preparation, characterization of modified wheat residue and its utilization for the anionic dye removal. Desalination. 267, 193-200.
17. Marchetti V., GeÂrardin P., Loubinoux B., 2000. Preparation and use of sawdusts bearing quaternary ammonium groups for removal of anionic dyes from water. European Journal of Wood and Wood Products. 58, 53-58.
18. Ansari R., Mosayebzadeh Z., 2010. Removal of Eosin Y, an Anionic Dye, from Aqueous Solutions Using Conducting Electroactive Polymers. Iranian Polymer Journal. 19, 541-551.
19. Poulios I., Micropoulou E., Panou R., Kostopoulou E., 2003. Photooxidation of eosin Y in the presence of semiconducting oxides. Applied Catalysis B. 41, 345–355.
20. Zheng H., Pan Y., Xiang X., 2007. Oxidation of acidic dye Eosin Y by the solar photo-Fenton processes. Journal of Hazardous Materials. 141, 457–464.
21. Purkait M.K., Banerjee S., Mewara S., DasGupta S., De S., 2005. Cloud point extraction of toxic eosin dye using Triton X-100 as nonionic surfactant. Water Research. 39, 3885–3890.
22. Pandit P., Basu S., 2004. Removal of Ionic Dyes from Water by Solvent Extraction Using Reverse Micelles. Environmental Science & Technology. 38, 2435-2442.
23. Du W.L., Xu Z.R., Han X.Y., Xu Y.L., Miao Z.G., 2008. Preparation, characterization and adsorption properties of chitosan nanoparticles for eosin Y as a model anionic dye. Journal of Hazardous Materials. 153, 152–156.
24. Kang Q., Zhou W., Li Q., Gao B., Fan J., Shen D., 2009. Adsorption of anionic dyes on poly(epicholorohydrindimethylamine) modified bentonite in single and mixed dye solutions. Applied Clay Science. 45, 280–287.
25. Porkodi K., Kumar K.V., 2007. Equilibrium, kinetics and mechanism modeling and simulation of basicand acid dyes sorption onto jute fiber carbon: Eosin yellow, malachitegreen and crystal violet single component systems. Journal of Hazardous Materials. 143, 311–327.
26. Purkait M.K., DasGupta S., De S., 2005. Adsorption of eosin dye on activated carbon and its surfactant based desorption. Journal of Environmental Management. 76, 135–142.
27. Huang X., Bin J., Bu H., Jiang G., Zeng, M., 2011. Removal of anionic dye eosin Y from aqueous solution using ethylenediamine modified chitosan, Carbohydrate Polymers. 84, 1350–1356.

28.Elhami Sh., Sharifi M., 2014. Development of an efficient procedure for the preconcentration of Copper(II) after solid phase extraction on modified sawdust, Bulletin of the Chemical Society of Ethiopia. 28(3), 321-328.

29.Mall I.D., Srivastava V.C., Agarwal N.K., 2006. Removal of Orange-G and Methyl Violet dyes by adsorption onto bagasse fly ash—kinetic study and equilibrium isotherm analyses. Dyes and Pigments. 69, 210-223.

30.Njiki Ch.P.N., Dedzo G.K., Ngameri E., 2010. Study of the removal of paraquat from aqueous solution by biosorption onto Ayous (Triplochiton schleroxylon) sawdust. Journal of Hazardous Materials. 179(1-3), 63-71