Design and Production of a Pneumatic Moving Exciter for Determination of Vibration Behavior of Structures in Variable Frequencies

Journal of Simulation and Analysis of Novel Technologies in Mechanical Engineering

مقاله 4، دوره 4، شماره 2، آذر 2011، صفحه 41-48   

نوع مقاله: Persian

نویسندگان

Firooz Bakhtiari-Nejad^{* 1}؛ Maysam Mirzaei²؛ Mahdi Vahabi³؛ Amirabolfazl Soratgar⁴

¹Professor, Department of Mechanical Engineering, Amir Kabir University of Technology

²M.SC., Department of Mechanical Engineering, Amir Kabir University of Technology

³M.SC. Student, Department of Mechanical Engineering, Amir Kabir University of Technology

⁴Assistant Professor, Department of Mechanical Engineering, Amir Kabir University of Technology

چکیده

Determination and analysis of vibration behavior of structures for at least first few natural frequencies and mode shapes needs several sensors to be connected at different non node points and exciting the structure at one point. Other method for determination of first few mode shapes is to excite several points of the structure at once and sensing the response from one point.  Both methods need several force or accelerometer sensors. Excitation of the structure can be done by impulse from a hammer, electromagnetic, pneumatic, and acoustic or laser exciters. Other method for determination of mode shapes with only one accelerometer sensor and one force transducer is possible by a moving exciter with predetermined velocity. Force excitation can be from electromagnetic, hydraulic or pneumatic system. Pneumatic type of excitation which is clean and is sensitive to small changes is used to design a moving non touching exciter for structures. This type of exciter is useful for determination of vibration behavior of sensitive and fragile structures which hammer or touching electromagnetic system cannot be used. This paper presents a design and production of a pneumatic moving exciter of a structure. Excitation force can be impulse, step, ramp or harmonic with different speeds of moving excitation point. The system was used to excite a beam and results are verified with theoretical results.

کلیدواژه‌ها

Pneumatic exciter؛ Moving load؛ Impulse force؛ Harmonic force؛ Natural frequency؛ Mode Shape

مراجع

[1] Farshidi R., Trieu D., Park S.S., Non-contact experimental modal analysis using air excitation and a microphone array, Journal of Measurement, Vol. 43, 2010, pp.  755–765.

[2] Vanlanduit S., Daerden F., Guillaume P., Experimental modal testing using pressurized air excitation, Journal of Sound and Vibration, 2007, pp. 299 83–98 .

[3] Hagedorn P., DasGupta A., Vibrations and Waves in Continuous Mechanical Systems, 2007.

[4] Stahle C.V., Phase sepration technique for ground vibration testing Aerospace Engineering, 2000.

[5] Fatemi M. , Greeneaf James, Vibro-acoustography: An imaging modality based on ultrasound stimulated acoustic emission, Proc. Natl. Acad. Sci. USA, Vol. 96, 1999, pp. 6603–6608

[6] Kennedy C.C., Panuc C.D.P., Use of vectors in vibration measurement and analysis, Journal Aeronautical Science ,Vol. 14, Issue.11,1997.

[7] Shigley J.E., Mechanical Engineering Design, McGraw-Hill,1989.

[8] Kennedy C.C., Panuc C.D.P., Use of vectors in vibration measurement and analysis, Journal Aeronautical Science ,Vol. 14, Issue.11,1997.

[9] Beards C. E., Structural Vibration: Analysis and Damping, John Wiley &Sons Inc,1996.