Analysis of Roll Wear in Reshaping Using Finite Element Simulation

Journal of Simulation and Analysis of Novel Technologies in Mechanical Engineering

مقاله 1، دوره 2، شماره 1، آذر 2009، صفحه 1-9   

نوع مقاله: Persian

نویسندگان

Mehdi Salmani Tehrani^{* 1}؛ Reza Khodabande Shahraki²؛ Hesam Validi³

¹Assistant Professor, Mechanical Engineering Department, Shahrekord University

²M.Sc. Student, Mechanical Engineering Department, Islamic Azad university, Khomeinishahr Branch

³M.Sc., Tarbiat Modares University

چکیده

Reshaping process is a widely used method for producing tubes with non-circular cross sections. Owing to the friction between pipe and rolls, initial round pipe moves forward and consequently, it gradually formed into square or rectangular one. In practice, geometric profile of the rolls will be changed after a while. These changes would be detrimental the production of faultless products. Therefore, in this paper the reshaping process is studied considering wear phenomena on the rolls. This study is a co-operation with a related industry at which square tubes are produced using reshaping process. In order to investigate the production line, considering industrial datasheets, the process is modeled by means of a commercial FEM package, ABAQUS\Explicit. The reshaping process is simulated as a 3D model and subsequently the sustainable regions to wear are investigated. The influences of significant parameters such as material and thickness of strip, as well as friction coefficient on the worn area, are studied. At the end, the FEM reults are comprised with the experiments reults and a good consistency between them is seen.

کلیدواژه‌ها

Reshaping؛ Non-circular cross- section؛ Roll Wear؛ Finite Element Simulation

مراجع

[1]  Kiuchi M., Feizhou W., Reshaping of Round Pipes into Square and Rectangular Pipes, Tube & Pipe Technology, November / December 1999.

[2]  Hutchings I.M., Tribology, Friction and Wear of Engineering Materials, 1992.

[3]  Masen M., Abrasive Tool Wear in Metal Forming Processes, Ph.D. Thesis, University of Twente, Enschede, The Netherlands, September 2004.

[4]  ASM International Handbook Committee, Friction, Lubrication, and Wear Technology, Volume 18, 1992 .

[5]  Haffmann H., Hwang C., Ersoy A., Advanced Wear Simulation in Sheet Metal Forming, Institute of Metal Forming and Casting, 2002.

[6]  Mentor, Spilit Rolls, Solutions for the tube, Pipe&Roll Form Industries, Ohio, USA, 2006.

[7]  Hegadekatte v., Huber N., Kraft O., Finite element based simulation of dry sliding wear, Modeling Simul. Mater. Sci. Eng. 13, 2004,
pp. 57-75.

[8]  ABAQUS User Guid, ABAQUS Analysis User's Manual.