Presentation and Analysis of Methods for Increasing Glue Joint Strength in the Same Length Joint

Journal of Simulation and Analysis of Novel Technologies in Mechanical Engineering

مقاله 3، دوره 6، شماره 4، فروردین 2013، صفحه 19-24   

نوع مقاله: Persian

نویسندگان

A.H. Ehsani Ehsani^{* 1}؛ M. Shirzadian Gilan¹؛ A. Ghafori Sayad²؛ A. Shokrgozar Navi¹

¹Department of Mechanical Engineering, Firouzkouh Branch, Islamic Azad University, Mazandaran, Iran

²- Department of Mechanical Engineering, Firouzkouh Branch, Islamic Azad University, Mazandaran, Iran

چکیده

Glue joints are more useful in Aerospace so in this article we presented new method for glue joint. In this method the maximum stresses that occurs at the edges of the bottom glue joint and cause ultimate failure in this type of connection is Decrease and increase the glue joint strength. In this method glue in the area overlapping the discrete and separate column considered Also, the connection is assumed to be identical for the proposed method. As a result, in this case less glue is used for connection. At first the  proposed method has been studied to offer and distribute the tension in the glue is analyzed then modeling glue joints for common conditions and proposed with use of the finite element software for numerical analysis

کلیدواژه‌ها

Glue joints؛ Length joint؛ Joint strength؛ Stress distribution؛ Finite Element

مراجع

[1]     Goland .M, Reissner .E, The Stress in Cemented Joints. ASME Journal Applied Mechanics, Vol. 66, No. 4, 1944, pp. 17-27.

[2]     Wooley.G.R, Carver .O.R, Stress Concentration Factor For Bonded Lap Joints , Journal of Aircraft, Vol. 8, No.10 , 817-820. 1971.

 

[3]     Hart-Smith L.J, Adhesive-Bonded Single-Lap Joints, NASA, CR-1122,  vol. 36, 1973.

 

[4]     Chang D.J., Muki R., Stress Distribution in Lap Joint Under Tension-Shear, International  Journal of  SolidsStructures , Vol. 10 , No. 5, 1974, pp. 503-517.

 

 

[5]       قرابی م.ج.ا.ا ، احسانی ا.ح ، ارائه و تحلیل روش مناسب جهت افزایش استحکام اتصالات چسبی در حالت طول اتصال یکسان، کنفرانس بین المللی پژوهش های نوین در مهندسی، ایران دانشگاه آزاد اسلامی واحد خمینی شهر، اسفند 1391

 

[6]     Pereira A.B., Strength of Adhesively Bonded Stainless Steel Joints. International Journal of Adhesion & Adhesive, vol. 23, No. 8, 2003, pp. 315-322.

 

[7]     Fawiza S., Al-mahaidi R., Zhao X.–L., Experimental and Finite Element Analysis of a Double Strap Joint between Steel Plates and Normal Modulus CFRP, International Journal of  Composite Structure, In pres , rec., 2005.