Check Tic-coated Tungsten Carbide Tool Wear in Machining Steel

Journal of Simulation and Analysis of Novel Technologies in Mechanical Engineering

مقاله 6، دوره 6، شماره 4، فروردین 2013، صفحه 43-47   

نوع مقاله: Persian

نویسندگان

M. Karimian¹؛ , E. Mir Mohammad Sadeghi²؛ M. Mokhles Pour Esfahani^{* 3}؛ M. badakhshian³

¹Assistant Prof., Department of Mechanical Engineering, Khomeinishahr Branch, Islamic Azad University, Isfahan, Iran

²Lecturer, Department of Mechanical Engineering, Khomeinishahr Branch, Islamic Azad University, Isfahan, Iran

³MSc Student, Department of Mechanical Engineering, Khomeinishahr Branch, Islamic Azad University, Isfahan, Iran

چکیده

In industrial production systems, including the most important factors in the economic field machining operations, reduce tool wear due to abrasive nature of the phenomenon on many factors, including temperature Lathe tool, influences, machining conditions (cutting speed, speed losses, forcing to rebuild parts of the manufacturing tolerances disassemble tool wear is caused by the phenomenon, as well as large sums to replace or sharpen this tool. In this study, an in vitro study done on tool wear SNMM120404 and the effect of parameters such as rotation speed of the spindle chuck, feed rate and depth of tool wear is investigated

کلیدواژه‌ها

Lathe؛ fluid shear stress؛ abrasion tool؛ round spindle؛ depth chip Level

مراجع

[1] الحافی،حسن،ماشین کاری های پیشرفته،دانشگاه صنعتی خواجه نصیرالدین طوسی،1390.

[2] گلکارپور. هانی، دهقانی. نریمان ، بررسی عمر ابزار با توجه به پارامترهای حرارت ، صافی.

[3] Derflinger V., Brandle H., Zimmermann H., New hard/lubricant coating for dry machining, Surface and Coatings Technology, vol. 113, No. 3, 1999, pp. 286–292.

[4] Sarma D.K., Dixit A., A comparison of dry and aircooled turning of grey cast iron with mixed oxide ceramic tool, Journal of Materials Processing Technology, vol. 190, No. 1-3 , 2007 , pp. 160-172.

[5] Dhar N.R., Kamruzzaman M., Ahmed M., Effect of minimum quantity lubrication (MQL) on tool wear and surface roughness in turning AISI-420B steel, Journal of Materials Processing Technology, vol. 172, No. 2, 2012, pp. 299-304.

[6] Machado, A.R., Wallbank, J., The effect of extremely low lubricant volumes in machining, Wear, vol. 210, No. 1, 1997, pp. 76-82.

[7] Xavior M.A., Adithan M., Determining the influence of cutting fluids on tool wear and surface roughness during turning of AISI 304 austenitic stainless steel, Journal of Materials Processing Technology, Vol. 209, No. 2, 2009, pp. 900-909.