Passivity of AISI 316L stainless steel as a function of nitric concentration

Journal of Advanced Materials and Processing

مقاله 4، دوره 2، شماره 2، مرداد 2014، صفحه 21-30   

نوع مقاله: Research Paper

نویسندگان

Arash Fattah-alhosseini^* ؛ Mohamad Ali Sonamia؛ Atena Loghmani؛ Fariba Zerafati Shoja

Faculty of Engineering, Bu-Ali Sina University, Hamedan,Iran

چکیده

In this study, electrochemical behaviour of passive films formed on AISI 316L stainless steel (AISI 316L) in three acidic solutions concentrations (0.3, 0.6, and 0.9M HNO3) under open circuit potential conditions were evaluated by potentiodynamic polarization, Mott–Schottky analysis and electrochemical impedance spectroscopy (EIS) techniques. The potentiodynamic polarization results showed that the corrosion potentials of AISI 316L shift towards positive direction with increase in solution concentration. Also, these results reveal that the corrosion rate of AISI 316L is enhanced in solutions with higher nitric content. Mott–Schottky analysis revealed that passive films behave as p-type and n-type semiconductors at potentials below and above the flat band potential, respectively. Also, Mott–Schottky analysis indicated that the donor and acceptor densities increased with solution concentration. EIS data showed that the equivalent circuit Rs((RctQdl)(RfQf)) by two time constants is applicable. Also, EIS results reveal that the charge transfer resistance and passive film resistance decrease with solution concentration.

کلیدواژه‌ها

EIS؛ p-type semiconductor؛ n-type semiconductor؛ Mott–Schottky

مراجع

1. Z. Shi G. Song, CN. Cao, H. Lin, M. Lu, “Electrochemical potential noise of 321 stainless steel stressed under constant strain rate testing conditions”, Electrochim. Acta., Vol. 52, 2007, pp. 2123–2133.
2. AA. Hermas, MS. Morad, “A comparative study on the corrosion behaviour of 304 austenitic stainless steel in sulfamic and sulfuric acid solutions”, Corros. Sci., Vol. 50, 2008,
   pp. 2710–2717.
3. NE. Hakiki, M. Da Cunha Belo, AMP. Simões, MGS. Ferreira, “Semiconducting properties of passive films on stainless steel. Influence of the alloying elements”, J Electrochem. Soc., Vol. 145, 1998, pp. 3821–3289.
4. MC. Li, H. Zhang, RF. Huang, SD. Wang, HY. Bi, “Effect of SO₂ on oxidation of type 409 stainless steel and its implication on condensate corrosion in automotive mufflers”, Corros. Sci., Vol. 80, 2014, pp. 96–103.
5. A. Fattah-alhosseini, F. Soltani, F. Shirsalimi, B. Ezadi, N. Attarzadeh, “The semiconducting properties of passive films formed on AISI 316 L and AISI 321 stainless steels: A test of the point defect model (PDM)”, Corros. Sci., Vol. 53, 2011, pp. 3186–3192.
6. S. Ningshen, UK. Mudali, G. Amarendra,
   B. Raj, “Corrosion assessment of nitric acid grade austenitic stainless steels”, Corros. Sci., Vol. 51, 2009, pp. 322–329.
7. S. Ningshen, UK. Mudali, G. Amarendra,
   B. Raj, “Corrosion behaviour of AISI type 304L stainless steel in nitric acid media containing oxidizing species”, Corros. Sci., Vol. 53, 2011, pp. 64–70.
8. N. Padhy, S. Ningshen, UK. Mudali, G. Amarendra, B. Raj. “In situ surface investigation of austenitic stainless steel in nitric acid medium using electrochemical atomic force microscopy”, Scripta Materialia, Vol. 62, 2010, pp. 45–48.
9. N. Padhy, S. Ningshen, UK. Mudali, G. Amarendra, B. Raj, “Morphological and compositional analysis of passive film on austenitic stainless steel in nitric acid medium”, Appl. Surf. Sci., Vol. 257, 2011, pp. 5088–5097.

10. A. Fattah-alhosseini, MM. Khalvan, “Semiconducting properties of passive films formed on AISI 420 stainless steel in nitric acid solutions”, J. Advan. Mater. Process., Vol. 2, 2013, pp. 15–22.

11. K. Azumi, T. Ohtsuka, N. Sata, “Mott-Schottky plot of the passive film formed on iron in neutral borate and phosphate solutions”, J. Electrochem. Soc., Vol. 134, 1987, pp. 1352–1358.

12. DD. Macdonald, KM. Ismail, E. Sikora “Characterization of the passive state on zinc”, J. Electrochem. Soc., Vol. 145, 1998,
pp. 3141–3149.

13. E. McCafferty, “Validation of corrosion rates measured by the Tafel extrapolation method”, Corros. Sci., Vol. 47, 2005, pp. 3202–3215.

14. H. Luo, XG. Li, CF. Dong, K. Xiao, XQ, Cheng, “Influence of uv light on passive behavior of the 304 stainless steel in acid solution”, J. Phys. Chem. Solid., Vol. 74, 2013, pp. 691–697.

15. Y. Yang, LJ. Guo, H. Liu, “Effect of fluoride ions on corrosion behavior of SS316L in simulated proton exchange membrane fuel cell (PEMFC) cathode environments”, J. Power Sourc., Vol. 195, 2010, pp. 5651–5659.

16. J. Ding, L. Zhang, M. Lu, J. Wang, Z. Wen,
W. Hao, “The electrochemical behaviour of 316L austenitic stainless steel in Cl⁻containing environment under different H₂S partial pressures”, Appl. Surf. Sci., Vol. 289, 2014,
pp. 33– 41.

17. C. Escrivà-Cerdán, E. Blasco-Tamarit, DM. García-García, J. García-Antóna, A. Guenbour. “Effect of potential formation on the electrochemical behaviour of a highly alloyed austenitic stainless steel in contaminated phosphoric acid at different temperatures”,  Electrochim. Acta., Vol. 80, 2012, pp. 248–256.

18. DD. Macdonald, “On the existence of our metals-based civilization I. Phase-space analysis”, J. Electrochem. Soc. Vol. 153, 2006,
pp. B213–B224.

19. DD. Macdonald, “On the tenuous nature of passivity and its role in the isolation of HLNW”, J. Nuclear Materials. Vol. 379, 2008, pp. 24–32.

20. A. Fattah-alhosseini, MA. Golozar, A. Saatchi, K. Raeissi, “Effect of solution concentration on semiconducting properties of passive films formed on austenitic stainless steels”, Corros. Sci. Vol. 52, 2010, pp. 205-209.

21. N. Sato, “An overview on passivity on metals”, Corros. Sci., Vol. 31, 1990, pp. 1–19.

22. MGS. Ferreira, NE. Hakiki, G. Goodlet, S. Faty, AMP. Simões, M. Da Cunha Belo, “Influence of the temperature of film formation on the electronic structure of oxide films formed on 304 stainless steel”, Electrochim. Acta., Vol. 46, 2001, pp. 3767–3776.

23. EE. Oguzie, J. Li, Y. Liu, D. Chen, Y. Li, K. Yang, F. Wang, “The effect of Cu addition on the electrochemical corrosion and passivation behavior of stainless steels”, Electrochim. Acta., Vol. 55, 2010, pp. 5028–5035.

24. L. Jinlong, L. Hongyun. “Comparison of corrosion properties of passive films formed on phase reversion induced nano/ultrafine-grained 321 stainless steel”, Appl. Surf. Sci., Vol. 280, 2013, pp. 124–131.

25. M. Criado, DM. Bastidas, S. Fajardo, A. Fernández-Jiménez, JM. Bastidas, “Corrosion behaviour of a new low-nickel stainless steel embedded in activated fly ash mortars”, Cem. Concr. Comp., Vol. 33, 2011, pp. 644–652.