Optimization of Location and Stiffness of an Intermediate Support to Maximize the First Natural Frequency of a Beam with Tip Mass-With Application

ADMT Journal

دوره 15، شماره 1، خرداد 2022، صفحه 125-132   

نوع مقاله: Original Article

شناسه دیجیتال (DOI): 10.30486/admt.2022.1933790.1291

نویسندگان

Hossein Ebrahimi؛ Farshad Kakavand^* ؛ Hassan Seidi

Department of Mechanical Engineering, Takestan Branch, Islamic Azad University, Takestan, Iran

چکیده

The optimal position and minimum stiffness of an intermediate support is implemented to maximize the fundamental natural frequency of a vibrating cantilever Euler-Bernoulli beam with tip mass. According to Courant’s maximum-minimum theorem, maximum value of the first natural frequency of a beam with a single additional rigid internal support, is equal to the second natural frequency of the unsupported beam. In literature, for a cantilever beam without tip mass, the optimum position of intermediate support was reported as 0.7834L and minimum dimensionless stuffiness as 266.9. In this paper, the effect of tip mass ratio on optimum location and minimum stiffness is investigated. The Finite element method is employed. Cross sectional area is uniform and material is homogeneous and isotropic. Numerical results demonstrate that as tip mass ratio increases the optimal position moves toward the tip mass and minimum stiffness increases. For instance, for tip mass ratio 0.5, optimal position is 0.92L and minimum dimensionless stiffness is 284. Optimal position and minimum stiffness are presented for various range of mass ratio. In many applications, it is not possible to place intermediate support at optimal position; therefore, the minimum stiffness does not exist. In these cases, a tolerances zone is considered and related design curves are proposed. As a practical example, an agitator shaft is considered and end impeller is modeled as tip mass. The effectiveness of the proposed design curves in order to maximize natural frequency is shown. A design of an intermediate support is presented; in this example the fundamental frequency has increased as much as 300 percent without any change in shaft diameter.

کلیدواژه‌ها

Euler-Bernoulli؛ Intermediate Support؛ Optimal Position and Minimum Stiffness

مراجع

• Courant, R., Hilbert, D., Methods of Mathematical Physics, Interscience Publishers, New York, 1953.
• Olhoff, N., Akesson, B., Minimum Stiffness of Optimally Located Supports for Maximum Value of Column Buckling Loads, Structural Optimization, Vol. 3, No. 3, 1991, pp. 163-175, https://doi.org/10.1007/BF01743073.
• Wang, D., Friswell, M., and Lei, Y., Maximizing the Natural Frequency of a Beam with an Intermediate Elastic Support, Journal of Sound and Vibration, Vol. 291, No. 3, 2006, pp. 1229–1238, https://doi.org/10.1016/j.jsv.2005.06.028.
• Wang, C., Minimum Stiffness of an Internal Elastic Support to Maximize the Fundamental Frequency of a Vibrating Beam, Journal of Sound and Vibration, Vol. 259, No. 1, 2003, pp. 229–232, https://doi.org/10.1006/jsvi.2002.5100.
• Rao, C. K., Frequency Analysis of Clamped-Clamped Uniform Beams with Intermediate Elastic Support, Journal of Sound and Vibration, Vol. 133, No. 3, 1989, pp. 502–509, https://doi.org/1016/0022-460X(89)90615-9.
• Szelag, D., Mroz, Z., Optimal Design of Vibrating Beams with Unspecified Support Reactions, Computer Methods in Applied Mechanics and Engineering, Vol. 19, No. 3, 1979, pp. 333–349, https://doi.org/10.1016/0045-7825(79)90063-X.
• Albarracı́n, C. M., Zannier, L., and Grossi, R., Some Observations in the Dynamics of Beams with Intermediate Supports, Journal of Sound and Vibration, Vol. 271, No. 1-2, 2004, pp. 475–480, http://dx.doi.org/10.1016/S0022-460X(03)00631-X.
• Wang, D., Optimal Design of Structural Support Positions for Minimizing Maximal Bending Moment, Finite Elements in Analysis and Design, Vol. 43, No. 2, 2006, pp. 95–102, https://doi.org/10.1016/j.finel.2006.07.004.
• Motaghian, S., Mofid, M., and Alanjari, P., Exact Solution to Free Vibration of Beams Partially Supported by an Eastic Foundation, Scientia Iranica, Vol. 18, No. 4, 2011, pp. 861-866, https://doi.org/10.1016/j.scient.2011.07.013.
• Aydin, E., Minimum Dynamic Response of Cantilever Beams Supported by Optimal Elastic Springs, Structural Engineering and Mechanics, Vol. 51, No. 3, 2014, pp. 377–402, https://doi.org/10.12989/sem.2014.51.3.377.
• Goel, R., Vibrations of a Beam Carrying a Concentrated Mass, Journal of Applied Mechanics, Vol. 40, No. 3, 1973, pp. 821-832, https://doi.org/10.1115/1.3423102.
• Laura, P., Pombo, J., and Susemihl, E., A Note on the Vibrations of a Clamped-Free Beam with a Mass at the Free End, Journal of Sound and Vibration, Vol. 37, No. 2, 1974, pp. 161-168, https://doi.org/10.1016/S0022-460X(74)80325-1.
• Bruch, J., Mitchell, T., Vibrations of a Mass-Loaded Clamped-Free Timoshenko Beam, Journal of Sound and Vibration, Vol. 114, No. 2, 1987, pp. 341-345, https://doi.org/10.1016/S0022-460X(87)80158-X.
• Murgoze, M., On the Eigenfrequencies of a Cantilever Beam with Attached Tip Mass and a Spring-Mass System, Journal of Sound and Vibration, Vol. 190, No. 2, 1996, pp. 146-162, https://doi.org/10.1006/jsvi.1996.0053.
• Salarieh, H., Ghorashi, M., Free Vibration of Timoshenko Beam with Finite Mass Rigid Tip Load and Flexural–Torsional Coupling, International Journal of Mechanical Sciences, Vol. 48, No. 7, 2006, pp. 763-779, https://doi.org/10.1016/j.ijmecsci.2006.01.008.
• Magrab, E. B., Natural Frequencies and Mode Shapes of Timoshenko Beams with Attachments, Journal of Vibration and Control, Vol. 13, No. 7, 2007, pp. 905-934, https://doi.org/10.1177/1077546307078828.
• Kukla, S., Free Vibrations of Axially Loaded Beams with Concentrated Masses and Intermediate Elastic Supports, Journal of Sound and Vibration, Vol. 172, No. 4, 1994, pp. 449–458, https://doi.org/10.1006/jsvi.1994.1163.
• Lin, H. P., Chang, S., Free Vibration Analysis of Multi-Span Beams with Intermediate Flexible Constraints, Journal of Sound and Vibration, Vol. 281, No. 2, 2005, pp. 155–169, https://doi.org/10.1016/j.jsv.2004.01.010.
• Lin, H. Y., Tsai, Y. C., Free Vibration Analysis of a Uniform Multi-Span Beam Carrying Multiple Spring–Mass Systems, Journal of Sound and Vibration, Vol. 302, No. 3, 2007, pp. 442–456, https://doi.org/10.1016/j.jsv.2006.06.080.
• Lin, H. Y., Dynamic Analysis of a Multi-Span Uniform Beam Carrying a Number of Various Concentrated Elements, Journal of Sound and Vibration, Vol. 309, No. 1, 2008, pp. 262–275, https://doi.org/10.1016/j.jsv.2007.07.015.
• Kim, T., Lee, U., Dynamic Analysis of a Multi-Span Beam Subjected to a Moving Force Using the Frequency Domain Spectral Element Method, Computers and Structures, Vol. 192, 2017, pp. 181–195,https://doi.org/10.1016/j.compstruc.2017.07.028.
• Han, S. M., Benaroya, H., and Wei, T., Dynamics of Transversely Vibrating Beams Using Four Engineering Theories, Journal of Sound and Vibration, Vol. 225, No. 5, 1999, pp. 935–988, https://doi.org/10.1006/jsvi.1999.2257.
• Zohoor, H., Kakavand, F., Vibration of Euler–Bernoulli Beams in Large Overall Motion on Flying Support Using Finite Element Method, Scientia Iranica, Vol. 19, No. 4, 2012, pp. 1105–1116, https://doi.org/10.1016/j.scient.2012.06.019.